Aeg-Electrolux 41056VH-MN User Manual Page 42

  • Download
  • Add to my manuals
  • Print
  • Page
    / 44
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 41
Instruction on setting up42
Instruction on setting up
1 Important! The new appliance may only be installed and connected by qualified per-
sonnel.
Please observe this instruction, otherwise the warranty will not cover any damage that
may occur.
Setting up
In the units or furniture surrounding the appliance, veneers or plastic coatings must
have been made up using heat-resistant bonding agents (100°C). If plastic coatings or
cements are not sufficiently heat-resistant, the coating may be deformed or loosened.
The appliance may be installed up against tall units or walls on one side only.
The distance between the cooking surface and the cooker hood must as a minimum
be as great as that indicated in the installation instructions for the cooker hood.
If the appliance is being placed on a base, measures must be taken to prevent the ap-
pliance from sliding off the base.
Making the appliance level
Underneath the appliance there are
4 adjustable feet, which can be used to even
out small unlevelnesses in the floor.
1. Remove the pan drawer.
2. Turn the adjustable feet to make them higher
or lower as required, until the cooker is stand-
ing level.
3. Re-insert the pan drawer.
3 The adjustable feet are easier to turn, if the
cooker is tilted slightly to take the weight off
the foot.
1 Safety information for the installer
The set-up of the electrical installation is arranged so that the appliance can be isolat-
ed from the mains with a minimum 3 mm all-pole contact separation.
Suitable separation devices include e. g. cut-outs, fuses (screw fuses are to be taken
out of the holder), RCD’s and contactors.
Avoid installing the appliance next to doors and under windows. Otherwise hot cook-
ware may be knocked off the rings when doors and windows are opened.
The appliance must be connected to the electricity according to the connection sche-
matic on the outside of the terminal cover.
The cable which connects the appliance to the mains must correspond to insulation
standard H05VV-F (=227 IEC 53) as a minimum.
Page view 41
1 2 ... 37 38 39 40 41 42 43 44

Comments to this Manuals

No comments