Aeg-Electrolux B89090-5 User Manual download pdf (Page 48)

Instructions for the Installer

The instructions given below are

designed specifically for a qualified

installer and should aid him or her to

perform all installation, adjustment,

and maintenance operations with

absolute precision and in compliance

with all current legislation and

regulations. We strongly recommend

that all operations for the installation

of your cooker be carryed out by

Qualified Personnel in accordance with

existing rules and regulations.

Electrical connection

Prior to making the electrical connection, make

sure that:

— the protection fuse and the domestic

wiring system are suitable to carry the total

electric load of the oven (see rating plate);

— your domestic wiring system has an

efficient earth connection in compliance with

rules and laws in force;

— the wall socket or the omnipole switch

used for the electrical connection can easily

be reached after the oven is built in.

This appliance is delivered with an electric supply

cable.

A proper plug, according to the electric load

specified on the rating plate, must be fitted to

the cable. The plug is to be inserted into a suitable

wall socket. If you require a direct connection to

the electric network (mains), it will be necessary

to fit between the appliance and the mains an

omnipole switch, with a minimum gap between

contacts of 3 mm, suitable for the required load

and in compliance with rules in force. The green

& yellow ground wire must not be interrupted by

the switch and it should be 2-3 cm. longer than

the other cables.

Terminal block

The oven is fitted with an easily accessible

terminal block which is designed to operate

with a single-phase power supply of 230 V.

Letter L - Live terminal

Letter N - Neutral terminal

or E - Earth terminal

The mains cable and plug as supplied are to be

connected to a shockproof socket (230 V~, 50

Hz). The shockproof socket must be installed in

accordance with the regulations.

The following types of mains cable are suitable,

taking the necessary rated cross section into

account: H07 RN-F, H05 RN-F, H05 RR-F, H05

VV-F, H05 V2V2-F (T90), H05 BB-F.

The connection cable must in any case be laid

out so that at no point does it reach 50°C (over

room temperature).

After the connection has been carried out, the

heating elements must be tested by being

operated for about 3 minutes.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 54 55 56

Comments to this Manuals

No comments

Aeg-Electrolux B89090-5 User Manual Page 48

Comments to this Manuals

Related products and manuals for Ovens Aeg-Electrolux B89090-5