C.D.A.B.MAC 538E / MAC 539E 38 CCMAC 540E / PROMAC 40 II40 CCMAC 542E / CALIFORNIA 42 CCMAC 545E / PROMAC 46 II 46 CCP 538E / EUROMAC S42 / S44 38 CCP
Due to a constant product improvement programme, the factory reserves the right to modify technical detailsmentioned in this manual without prior noti
1 - BAR2 - CHAIN3 - FUEL TANK CAP4 - OIL TANK CAP5 - STOP SWITCH6 - STARTER HOUSING7 - STARTER HANDLE8 - FRONT HANDLE9 - AIR FILTER COVER10 - CHOKE KN
ENGLISH - 2Choke partially openedChoke closed (cold start)StoppingBrake engaged / disengagedBeware of kickbackDo not cut with the end on the bar,this
Ensure engine is always switched off before fitting oradjusting chain. Wear a pair of protective gloves whenfitting or adjusting chain.1 Ensure chain
ENGLISH - 4IMPORTANTNever start or operate unless bar and chain are properlyinstalled. Before starting always move the saw awayfrom the fuelling area
ENGLISH - 5Then open screw 1 full turn (counterclockwise) .If acceleration is not smooth, open another 1/8 turn toincrease fuel flow .• H: The needle
ENGLISH - 6The chain brake should snap into both positions.Ifstrong resistance is felt or lever does not move intoeither position, DO NOT USE YOUR SAW
ENGLISH - 7Engine will not start Engine runs badly The chainsaw runs Engine runs badly orbut does not cut well looses power when cuttingCheck STOP sw
Comments to this Manuals