Aeg-Electrolux L14950A User Manual download pdf (Page 14)

Interrupting a programme

Press the button 7 to interrupt a programme which is running, the corresponding light

starts blinking. Press the button again to restart the programme.

Cancelling a programme

Turn the selector dial to to cancel a programme which is running. Now you can select

a new programme.

Opening the door after the programme has started

When the machine is working and through the delay time, the door is locked. If, for any

reason, it is necessary to open it, set firstly the machine to pause by pressing the button

7 .

• If the DOOR symbol disappears from the display, the door can be opened.

• If the DOOR symbol stays on, and the door remains locked, this means that the machine

is already heating or that the water level is too high. In this case the door can not be

opened.

If you cannot open the door but you need to open it you have to switch the machine off

by turning the selector dial to

. After a few minutes the door can be opened (pay

attention to the water level and temperature !) .

After closing the door, it is necessary to select the programme and options again and to

press button 7 .

At the end of the programme

The machine stops automatically. The pilot light of button 7 goes off and a blinking

appears on the display. The acoustic signal sounds for a few minutes.

If you have chosen a programme or an option that ends with water left in the tub, follow

the below instruction to empty the water out:

•

turn the programme selector dial to

• select the draining or spinning programme

• reduce the spin speed if needed, by pressing the relevant button

•

press the button 7

• when the programme has finished the display shows a blinking

. On the display the

DOOR symbol disappears. The door can now be opened.

Turn the programme selector dial to

to switch the machine off. Remove the laundry

from the drum and carefully check that the drum is empty.

If you do not intend to carry out another wash, close the water tap. Leave the door open

to prevent the formation of mildew and unpleasant smells.

Stand by : once the programme has finished after a few minutes the energy saving system

will be enabled. The brightness of the display is reduced. By pressing any button the ap-

pliance will come out of the energy saving status.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 43 44

No comments

Aeg-Electrolux L14950A User Manual Page 14