Aeg-Electrolux L14950A User Manual download pdf (Page 38)

3. Set the hose correctly by loosening the

ring nut. After positioning the inlet

hose, be sure to tighten the ring nut

again to prevent leaks.

4. Connect the hose to a tap with a 3/4”

thread. Always use the hose supplied

with the appliance.

The inlet hose must not be lengthened. If it is

too short and you do not wish to move the

tap, you will have to purchase a new, longer

hose specially designed for this type of use.

Installation should comply with local water

authority and building regulations require-

ments. Check the minimum water pressure

required for safe operation of the appliance

in the chapter "Technical Data".

Water-stop device

The inlet hose is provided with a water stop de-

vice, which protects against damage caused by

water leaks in the hose which could develop due

to natural ageing of the hose. This fault is shown

by a red sector in the window «A». Should this oc-

cur, turn the water tap off and refer to your Serv-

ice Centre to replace the hose.

Water drainage

The end of the drain hose can be positioned in three ways:

Hooked over the edge of a sink using the plastic hose guide supplied with the

machine.

In this case, make sure the end cannot come unhooked when the machine is emptying.

38 Installation

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 44

No comments

Aeg-Electrolux L14950A User Manual Page 38