Aeg-Electrolux L61470BI User Manual

USER MANUALEN User ManualWashing MachineL 61470 BI

ProgrammeMaximum and Minimum TemperatureType of LaundryMaximum LoadCycle De-scriptionOptionsWolle/Seide 40° - ColdMax. load 2 kgMachine washable wool

ProgrammeMaximum and Minimum TemperatureType of LaundryMaximum LoadCycle De-scriptionOptionsMix 20° 4)20°Max. load 3 kgSpecial programme for cotton, s

Programmes Load(Kg)Energyconsump-tion (kWh)Water con-sumption(litre)Approxi-mate pro-grammeduration(minutes)Remain-ing mois-ture (%)1)Cottons 60 °C 7

Make sure that no laundry stays betweenthe seal and the door. There is a risk ofwater leakage or damage to the laundry.9.2 Filling the detergent and a

If you turn the programme dial toanother programme when theappliance is working, the yellowpilot light of button 8 blinks 3times. The display shows th

The display shows the decreased wash-ing time.9.10 Starting the programme(button 8)Press the button 8 to start the pro-gramme. The corresponding red p

If the light B after a few minutes goesoff, the door can be opened.If the light B stays on and the door re-mains locked, this means that the ma-chine

We recommend that you remove thesestains before you put the items in theappliance.Special stain removers are available. Usethe special stain remover t

11.3 Door sealRegularly examine the seal and removeall objects from the inner part.11.4 DrumRegularly examine the drum to preventlimescale and rust pa

11.6 Drain pump lterThe pump should be inspected regularlyand particularly if:• the appliance does not empty and/orspin;• the appliance makes an unu

CONTENTS1. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32. SAFETY

7.Check carefully whether the pumpimpeller rotates (it rotates jerkily). Ifit doesn’t rotate, please contactyour Service Centre.8.Put the cap back on

4.Remove the inlet hose behind theappliance.5.Clean the filter in the valve with astiff brush or a towel.45°20°6.Install again the inlet hose. Makesur

During machine operation it is possiblethat the yellow pilot light of button 8blinks, one of the following alarm codesappears on the display and at th

Problem Possible cause/SolutionThe machine does notempty and/or does notspin:The drain hose is squashed or kinked. • Check the drain hose connection.T

Problem Possible cause/SolutionThe machine vibratesor is noisy:The transit bolts and packing have not been re-moved.• Check the correct installation o

13. INSTALLATION13.1 Unpacking1.Use the gloves. Remove the externalfilm. If necessary, use a cutter.2.Remove the cardboard top.3.Remove the polystyren

6.Put one of the polystyrene packag-ing elements on the floor behindthe appliance. Carefully put downthe appliance with the rear side onit. Make sure

12.Put the plastic caps in the holes.You can find these caps in the usermanual bag.WARNING!Remove all the packaging andthe transit bolts before you in

13.3 The inlet hose20O20O20O45O45O45O• Connect the hose to the appliance.Turn the inlet hose only left or right.Loose the ring nut to set it in the co

With the plastic hose guide. • On the edge of a sink.• Make sure that the plastic guide can-not move when the appliance drains.Attach the guide to the

1. SAFETY INFORMATIONBefore the installation and use of the appliance, careful-ly read the supplied instructions. The manufacturer isnot responsible i

You can extend the drain hose tomaximum 400 cm. Contact theservice centre for the other drainhose and the extension.14. BUILDING IN14.1 Building in600

Fig. 312• HingesTo mount the hinges it is necessary todrill two holes (dia. 35 mm, depth12.5-14 mm depending on the depthof door furniture) on the inn

ABCEDIf the door has to be opened from left toright, invert the position of the plates E ,the magnet D and the plate C. Mountthe counter-magnet D and

ENGLISH 33

34www.aeg.com

ENGLISH 35

www.aeg.com/shop132930394-A-022017

• If the supply cord is damaged, it must be replaced bythe manufacturer, its service agent or similarly quali-fied persons in order to avoid a hazard.

Water connection• Make sure not to cause damage to thewater hoses.• The appliance is to be connected tothe water mains using the new sup-plied hose-se

Water supply pressure Minimum 0,5 bar (0,05 MPa)Maximum 8 bar (0,8 MPa)Water supply 1) Cold waterMaximum load Cotton 7 kgSpin speed Maximum 1400 rpm1

4.2 Child safety device• When you activate this device, youcannot close the door. This preventschildren or pets to be closed in thedrum. To activate t

Duration of the set programmeWhen you set a programme, the display shows the duration inhours and minutes (for example 2.05).The duration is calculate

events of operating problems). By press-ing these two buttons again, the acous-tic signal is reactivated.5.4 Child safety lockThis device permits you