Aeg-Electrolux S75348KG8 User Manual download pdf (Page 59)

If something does not work

During operation of the appliance some smaller but annoying trouble can

often occur, which does not require calling a technician out. In the following

chart information is given about them to avoid unnecessary charges on serv-

ice.

We draw your attention that operation of appliance goes with certain sounds

(compressor- and circulating sound). This is not trouble, this goes together

with the operation of the appliance.

We draw it to your attention again that the appliance operates discontinu-

ously, so the stopping of compressor does not mean being no-current. That

is why you must not touch the electrical parts of the appliance before break-

ing the circuit.

Problem

It is too warm in the

refrigerator.

It is too warm in the

freezer.

Water flows at the

back plate in the

refrigerator.

Water flows into the

chamber.

Water flows onto the

floor.

There are too much

frost and ice.

Possible cause

Thermostatic control can be set

wrongly.

If products are not cold enough or

placed wrongly.

The door does not close tightly or it is

not shut properly.

Thermostatic control can be set

wrongly.

The door does not close tightly or it is

not shut properly.

Products in big quantity to be frozen

were put in.

Products to be frozen are placed too

closely to each other.

It is normal. During automatic defrost-

ing frost melts on the back plate.

The outlet of the chamber can be

clogged up.

Products placed in can prevent water

from flowing into the collector.

The melting water outlet flows not

into the evaporative tray above the

compressor.

Products are not wrapped properly.

Doors are not shut properly or do not

close tightly.

The thermostatic control can be set

wrongly.

Solution

Set the thermostat knob to higher

position.

Place the products according to the

chapter „Storing in the refrigerator”.

Check if the door closes well and the

gasket is unhurt and clean.

Set the thermostat knob to higher

position.

Check if the door closes well and the

gasket is unhurt and clean.

Wait some hours and then check the

temperature again.

Place the products in a way so that

cold air could circulate among them.

Clean the outlet.

Replace the products so that they can

not touch the back plate directly.

Put the melting water outlet to the

evaporative tray.

Wrap the products better.

Check if the doors close well and the

gaskets are unhurt and clean.

Set the thermostat knob to a position

that gives higher temperature.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 67 68

Comments to this Manuals

No comments

Aeg-Electrolux S75348KG8 User Manual Page 59

Comments to this Manuals

Related products and manuals for Combi-fridges Aeg-Electrolux S75348KG8