FAVORIT 44080 iDishwasherUser information
10Filling Up with Rinse AidRinse aid causes the rinse water to flow easily from the crockery leav-ing gleaming dishes and glassware. If you do not use
11Setting the Amount of Rinse Aid Required3 Only change the amount dispensed, if smears, milky spots (reduce the amount) or dried on water spots (incr
12In daily useLoading cutlery and dishes1 Sponges, cleaning cloths and any other objects that can absorb water must not be washed in the dishwasher. P
13Loading cutlery1 Warning: Sharp knives and other items of cutlery with sharp edges must be laid in the cutlery rack or in the upper basket to avoid
14To make it easier to load larger dish-es, the two plate racks on the right in the lower basket can be folded down. Cups, Glasses, Coffee ServiceLoad
15Adjusting the Height of the Upper Basket3 The height of the baskets can also be adjusted when they are loaded. Raising / Lowering the upper bas-ket
162. Place the detergent in the detergent dispenser. The markings indicate the dosing levels for powder detergents: “20/30” corresponds to approx. 20/
17Using 3in1 detergentsThese products are detergents with a combined cleaning, rinsing and salt function.When the 3in1 function is activated, – the ad
18Selecting the dishwashing cycle (Cycle Table)Dishwashing-cycleSuitablefor:Type of soilingProgramme sequenceConsumptionvalues1)1) The consumption val
19Selecting a programmeWhen your dishes look like this, select:an intensive programme.a normal or energy-saving pro-gramme.a short programme (e.g. 30
2Dear Customer,Please read this user information carefully and keep it to refer to later.Please pass the user information on to any future owner of th
20Starting a Dishwashing Cycle1. Check that the spray arms can turn freely.2. Turn the water tap on fully.3. Close the door.4. Press the ON/OFF button
213. Select dishwashing cycle.The LED indicator for the programme selected and the indicator next to the number of hours will light up.The dishwashing
22Care and cleaning1Do not use furniture care products or aggressive cleaners.• When necessary, clean the dishwasher’s controls with a soft cloth.• Oc
235. Remove the flat filter (3) from the base of the washing compartment and clean both surfaces thoroughly.6. Re-insert the flat filter.7. Place the
243. Place cleaned upper basket spray arm back in position against the connect-ing piece: press the two together firmly, until you feel them snap into
25What to do if...Remedying small malfunctionsIf while the appliance is operating indicators on the control panel flash or are lit up as described in
26the indicator for the end of the dishwashing cycle is flashing in sequence 3 short light signals one after anoth-er.The anti-flood system has been t
27If the Dishwashing Results are not SatisfactoryThe dishes are still dirty.• The wrong dishwashing cycle was selected.• The dishes were loaded is suc
28Disposal2Packaging materialThe packaging materials are environmentally friendly and can be recy-cled. The plastic components are identified by marki
29Technical Data 5 This appliance conforms with the following EU Directives:– 73/23/EEC dated 19.02.1973 Low Voltage Directive– 89/336/EEC dated 03.05
3ContentsOperating Instructions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4Safety . . . . . . . . . . . . . . . . . . .
30Notes for Test InstitutesTesting in accordance with EN 60704 must be carried out with the appliance fully loaded and using the test cycle (see “Cycl
31 Lower basket with cutlery basket *)Cutlery basket *) If there are cup racks in place on the lefthand side or if beer glass holders are in place, re
32Installation and connection instructions1 Safety Information for the Installation• Only transport the dishwasher in an upright position, otherwise s
33Installing the Dishwasher• The dishwasher must be installed on a firm floor and adjusted to en-sure that it is stable and level in all directions.•
34Connecting the dishwasherConnecting to the water supply • The dishwasher can be connected to cold and hot water supplies up to max. 60°C.• The dishw
35Water drainageDrain hose1 The drain hose must not be kinked, crushed or entangled.Connecting the drain hose:– Maximum permitted height: 1 metre.– Mi
36Electrical ConnectionAny electrical work required to install this appliance should be car-ried out by a qualified electrician or competent person.1
37Connecting systemsThe water inlet hose, drain hose and the mains cable must all be con-nected to the side of the dishwasher as there is no space for
38Warranty conditionsGreat BritainStandard guarantee conditionsWe, AEG, undertake that if within 12 months of the date of the purchase this AEG applia
39Service and Spare PartsIf the event of your appliance requiring service, or if you wish to pur-chase spare parts, please contact Service Force by te
4Operating Instructions1 SafetyPrior to using for the first time• Follow the ”Instructions for installation and connection”.Correct Use• The dishwashe
From the Electrolux Group. The world´s No.1 choice.The Electrolux Group is the world´s largest producer of powered appliances for kitchen, cleaning an
5Diagram of Appliance Control Panel The ON/OFF button is used to turn the dishwasher on and off.Top Spray NozzleUpper basket spray arm and lower spr
6 The Programme buttons are used to select the desired dishwashing cy-cle.Function buttons: In addition to the pre-set dishwashing cycle, the follow
7Prior to Using for the First Time3If you wish to use 3 in 1 detergent:– First read the section “Using 3in1 detergents”.– Do not fill up with special
83. Press function button 1.The LED indicator for function button 1 will flash.The LED indicator for the end of the dishwashing cycle will flash si
9Adding dishwasher SaltTo decalcify the water softener, it must be filled up with dishwasher salt. Use only special salt suitable for domestic dishwas
Comments to this Manuals