Aeg-Electrolux FAV44080VI User Manual download pdf (Page 34)

Connecting the dishwasher

Connecting to the water supply

• The dishwasher can be connected to cold and hot water supplies up

to max. 60°C.

• The dishwasher must not be connected to open hot water appliances

or instantaneous water heaters.

Permitted water pressure

Connecting the inlet hose

1 The water inlet hose must not be kinked, crushed or entangled when it

is being connected.

Connect the threaded hose fitting (ISO 228-1:2000) on the water inlet

hose to a tap with an external thread (¾ inch). The inlet hose is fitted

with either a plastic or a metal nut:

– Only tighten the nut hand tight.

Then do a visual check for water tightness. (Make sure that the tap is

not dripping.)

3 So that access to the tap in the kitchen is not restricted by the use of

the dishwasher, we recommend installing an additional tap, or fitting a

T-branch to the existing tap.

If you need a longer water inlet hose than that supplied, the following

VDE-approved complete hose sets are to be used. These are available

from your local service centre.

Lowest permitted water pressure:

1 bar (=10 N/cm2 =100 kPa)

Consult your plumber if the water pres-

sure is less than 1 bar.

Highest permitted water pressure:

10 bar (=100 N/cm2 =1 MPa)

If the water pressure is greater than 10

bar, a pressure reduction valve must be

used (available from your dealer).

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 43 44

No comments

Aeg-Electrolux FAV44080VI User Manual Page 34