Aeg-Electrolux SK71840-5I User Manual download pdf (Page 18)

Housing dimensions

Height 1780 mm

Depth 550 mm

Width 560 mm

Positioning

This appliance should only be installed at a location where the ambient

temperature corresponds to the climate classification indicated on the rat-

ing plate, which is located on the inside left of the appliance.

The following table shows which ambient temperature is correct for each

climate classification.

Climate classification for an ambient temperature of

SN +10 to +32 °C

N +16 to +32 °C

Your appliance needs air

For safety reasons, minimum ventila-

tion must be as shown Fig.

Attention: keep ventilation openings

clear of obstruction;

50 mm

min.

200 cm

min.

D567

Reversing the door

The side the door opens can be changed from the right side (factory adjust-

ment) to the left side, if the installation site requires.

Warning! When changing the side the door opens, the appliance must not

be connected to the mains. Remove plug from the mains beforehand.

The appliance should be located in a dry atmosphere, out of direct sunlight

and away from continuous heat and extreme temperature, e.g. not next to

a boiler or radiator, or in a very cold room e.g. an outhouse. If these tem-

peratures are exceeded i.e. warmer or colder, then the appliance may not

operate correctly.

For building-in and door reversal instructions please refer to the relevant

instructions on the following pages.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

No comments

Aeg-Electrolux SK71840-5I User Manual Page 18