AEG Electrolux EHS60160P User Manual download pdf (Page 30)

30 electrolux installation instructions

Installation Instructions

Safety instructions

Warning! This must be read!

The laws, ordinances, directives and

standards in force in the country of use

are to be followed (safety regulations,

proper recycling in accordance with the

regulations, etc.)

Installation may only be carried out by a

qualified electrician.

The minimum distances to other appli-

ances and units are to be observed.

Anti-shock protection must be provided

by the installation, for example drawers

may only be installed with a protective

floor directly underneath the appliance.

The cut surfaces of the worktop are to

be protected against moisture using a

suitable sealant.

The sealant seals the appliance to the

work top with no gap.

Avoid installing the appliance next to

doors and under windows. Otherwise

hot cookware may be knocked off the

rings when doors and windows are

opened.

z Risk of injury from electrical

current.

• The electrical mains terminal is live.

• Make electrical mains terminal free of

voltage.

• Follow connection schematic.

• Observe electrical safety rules.

• Ensure anti-shock protection by in-

stalling correctly.

• The appliance must be connected to

the electrical supply by a qualified

electrician.

z Risk of injury from electrical

current.

• Loose and inappropriate plug and

socket connections can make the

terminal overheat.

• Have the clamping connections cor-

rectly installed by a qualified electri-

cian.

• Use strain relief clamp on cable.

• In the event of single-phase or two-

phase connection, the appropriate

mains cable of type H05BB-F Tmax

90°C(or higher) must be used.

• If this appliance’s mains cable is

damaged, it must be replaced by a

special cable (type H05BB-F Tmax

90°C; or higher). The latter is availa-

ble from the Customer Care Depart-

ment.

A device must be provided in the electri-

cal installation which allows the appli-

ance to be disconnected from the mains

at all poles with a contact opening width

of at least 3 mm.

Suitable isolation devices include line

protecting cut-outs, fuses (screw type

fuses are to be removed from the hold-

er), earth leakage trips and contactors.

Sticking on the seal

• Clean the worktop around the cut-

out area.

• Stick the single-sided adhesive seal-

ing tape provided on the underside

of the hob around the outside edge

ensuring that it is not stretched. The

two ends of the tape should join in

the middle of one side. After trim-

ming the tape (allow it to overlap by

2-3 mm), press the two ends togeth-

er.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 103 104

Comments to this Manuals

No comments