Aeg-Electrolux ADT4241M User Manual download pdf (Page 13)

Problem Possible cause Solution

Water flows on the

ground.

The melting water outlet does

not flow in the evaporative tray

above the compressor.

Attach the melting water outlet

to the evaporative tray.

The temperature in the ap-

pliance is too low.

The temperature regulator is

not set correctly.

Set a higher temperature.

The temperature in the ap-

pliance is too high.

The temperature regulator is

not set correctly.

Set a lower temperature.

The door is not closed correctly. Refer to "Closing the door".

The product temperature is too

high.

Let the product temperature de-

crease to room temperature be-

fore storage.

Many products are stored at

the same time.

Store less products at the same

time.

There is no cold air circulation

in the appliance.

Make sure that there is cold air

circulation in the appliance.

Replacing the lamp

1. Disconnect the mains plug from the mains socket.

2. Remove the screw from the lamp cover.

3. Remove the lamp cover (refer to the il-

lustration).

4. Replace the used lamp with a new lamp

of the same power and specifically de-

signed for household appliances. (the

maximum power is shown on the lamp

cover).

5. Install the lamp cover.

6. Tighten the screw to the lamp cover.

7. Connect the mains plug to the mains socket.

8. Open the door. Make sure that the lamp comes on.

Closing the door

1. Clean the door gaskets.

2. If necessary, adjust the door. Refer to "Installation".

3. If necessary, replace the defective door gaskets. Contact the Service Center.

What to do if…

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 75 76

Comments to this Manuals

No comments

Aeg-Electrolux ADT4241M User Manual Page 13

Comments to this Manuals

Related products and manuals for Freezers Aeg-Electrolux ADT4241M