Aeg-Electrolux S70290DT8 User Manual download pdf (Page 40)

NP005

100 mm10 mm

10 mm

Installation

Installation Location

The appliance should be set up in a well ventilated, dry room.

Energy use is affected by the ambient temperature. The appliance should

therefore

– not be exposed to direct sunlight;

– not be installed next to radiators, cookers or other sources of heat;

– only be installed at a location whose ambient temperature corresponds to

the climate classification, for which the appliance is designed.

The climate classification can be found on the serial plate, which is located

at the left on the inside of the appliance.

The following table shows which ambient temperature is correct for each

climate classification: each climate classification:

Climate classification for an ambient temperature of

SN +10 bis +32 °C

N +16 bis +32 °C

ST +18 bis +38 °C

T +18 bis +43 °C

If installation next to a source of heat is unavoidable, the following minimum

clearances must be maintained at the sides of the appliance:

– for electric cookers 3 cm;

– for oil and coal fired ranges 30 cm.

If these clearances cannot be maintained a heat insulating pad is required

between the cooker and the refrigeration appliance.

If the refrigeration appliance is installed next to another refrigerator or

freezer a clearance of 5 cm at the sides is required, in order to prevent the

formation of condensation on the outside of the appliance.

Your appliance needs air

For safety reasons, minimum

ventilation must be as shown Fig.

Attention: keep ventilation

openings clear of obstruction;

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 51 52

No comments

Aeg-Electrolux S70290DT8 User Manual Page 40