Aeg-Electrolux BP5023001M User Manual download pdf (Page 28)

CAUTION!

If there are other appliances

installed in the same

cabinet, do not use them

when the Pyrolysis function

operates. It can cause

damage to the appliance.

1. Remove the worst dirt manually.

2. Clean the inner side of the door with

hot water, so that the residues do not

burn from the hot air.

3. Set the Pyrolysis function. Refer to

"Oven functions".

4. When flashes, press or to

set the necessary procedure:

Option Description

P1 If the oven is

not very dirty.

Time of the

procedure: 1

h 30 min.

P2 If you cannot

easily remove

the dirt. Time

of the proce-

dure: 2 h 30

min.

You can use the End function to delay

the start of the cleaning procedure.

During the Pyrolysis the oven lamp is off.

5. To change the default length of the

procedure (P1 or P2), press to set

, and then press or to set

the length of the cleaning procedure.

6. When the oven is at its set

temperature, the door locks. The

display shows the symbol and the

bars of the heat indicator until the

door unlocks.

7. When Pyrolysis is completed, the

display shows the time of day. The

oven door stays locked.

8. When the appliance is cool again, an

acoustic signal sounds and the door

unlocks.

10.4 Cleaning reminder

To remind you that the Pyrolysis is

necessary, PYR flashes in the display for

10 seconds after each activation and

deactivation of the appliance.

The cleaning reminder

goes out:

• after the end of the

Pyrolysis function.

• if you press and at

the same time while PYR

flashes in the display.

10.5 Removing and installing

the door

You can remove the door and the

internal glass panels to clean it. The

number of glass panels is different for

different models.

WARNING!

Be careful when you remove

the door from the appliance.

The door is heavy.

1. Open the door fully.

2. Fully press the clamping levers (A) on

the two door hinges.

A

A

3. Close the oven door to the first

opening position (approximately 70°

angle).

4. Hold the door with one hand on each

side and pull it away from the

appliance at an upwards angle.

5. Put the door with the outer side

down on a soft cloth on a stable

surface. This is to prevent scratches.

6. Hold the door trim (B) on the top

edge of the door at the two sides

and push inwards to release the clip

seal.

www.aeg.com

28

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 39 40

Comments to this Manuals

No comments