AEG Electrolux 700 D Operations Instructions download pdf (Page 27)

UPS overload Remove loads that are less

important

Battery voltage is too low Charge the battery for at

least 8 hours

Data backup time is

only very short on

power failure

Battery fault die to high

temperature in the

operating environment or

incorrect treatment of the

battery;

advanced battery ageing

Renew the battery with a

battery of the same type

Fuse blown De-energise the unit; insert

a replacement fuse.

Mains normal, but

“Battery” LED flashes

Mains cable loose Insert the plug firmly

into the

non-heating appliance

socket of the UPS.

Software is not installed

correctly

Check the software settings.

Support is available at

www.AEGpartnerNet.com

Communication

between UPS and

computer interrupted

Cable not connected

properly

Check that the RS232/USB

cable is firmly connected to

the COM or USB port of the

computer and confirm the

settings again

If you cannot solve the problem that has occurred, stop the

entire procedure, switch off the UPS and disconnect the

connector from the socket. Please contact our hotline in this

case (see page 5).

Please have the serial number of the unit as well as the

purchase date at hand. The hotline will provide you with

technical support and can inform you about further

procedures once you have described the problem.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32

Comments to this Manuals

No comments

AEG Electrolux 700 D Operations Instructions Page 27

Comments to this Manuals