Aeg-Electrolux L52840 User Manual download pdf (Page 27)

Positioning and levelling

Install the machine on a flat hard floor.

Make sure that air circulation around the machine

is not impeded by carpets, rugs etc.

Before placing it on small tiles, apply a rubber

coating.

Never try to correct any unevenness in the floor

by putting pieces of wood, cardboard or similar

materials under the machine.

If it is impossible to avoid positioning the machine

next to a gas cooker or coalburning stove, an in-

sulating panel covered with aluminium foil on the

side facing the cooker or stove, must be inserted

between the two appliances.

The machine must not be installed in rooms where the temperature can drop below 0°C.

The water inlet hose and the drain hose must not be kinked.

Please ensure that when the appliance is installed, it is easily accessible for the engineer in

the event of a breakdown.

Carefully level by screwing the adjustable feet in or out. Never place cardboard, wood or

similar materials under the machine to compensate for any unevenness in the floor.

Water inlet

This appliance must be connected to a cold water supply.

1. Connect the hose to a tap with a 3/4”

thread. Always use the hose supplied with

the appliance.

Do not use the hose from your previ-

ous machine to connect to the water

supply.

2. The other end of the inlet hose which

connects to the machine can be turned as

showed in the picture.

Do not place the inlet hose down-

wards. Angle the hose to the left or

right depending on the position of

your water tap.

3. Set the hose correctly by loosening the

ring nut. After positioning the inlet hose,

Installation 27

1 2 ... 22 23 24 25 26 27 28 29 30 31 32

No comments

Aeg-Electrolux L52840 User Manual Page 27