Aeg-Electrolux L75280FL User Manual

L 75280 FL EN User manual

Spin phase is off.'Rinse Hold' function ison.5.10 Temperature button 10Press button 10 to change the defaulttemperature.- - = cold water5.11

ProgrammeTemperatureType of loadmax. weight ofloadCycle description FunctionsCottons + Pre-wash95° - ColdWhite and colouredcotton with heavysoil.max.

ProgrammeTemperatureType of loadmax. weight ofloadCycle description FunctionsRinse Hand washingitems.RinsesLong spinSPIN REDUC-TIONRINSE HOLDEXTRA RIN

STEAM PROGRAMMESProgramme1)Type of load Max. load Steam RefreshThis cycle removes odoursfrom the laundry.Steam does not re-move animal odours.Cotton a

Programmes Load(Kg)Energyconsump-tion (kWh)Water con-sumption(litre)Approxi-mate pro-grammeduration(minutes)Remain-ing mois-ture (%)1)Cottons 60 °C 8

9.1 Loading the laundry1.Open the appliance door.2.Put the laundry in the drum, oneitem at a time. Shake the items be-fore you put them in the applian

Flap for powder or liquid detergentTurn it (up or down) in the correct position to use powder or liq-uid detergent.Always obey the instructions that y

9.3 Setting and starting aprogramme1.Turn the programme knob. The rela-ted programme indicator comes on.2.The indicator of button 4 flasheswith red co

9.10 At the end of theprogramme• The appliance stops automatically.• The acoustic signals operate.•In the display comes on.• The indicator of the Sta

10.3 Detergents and additives• Only use detergents and additivesspecially made for washing machines.• Do not mix different types of deter-gents.• To h

CONTENTS1. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32. SAFETY

• Use a correct quantity of powder de-tergent with biological properties.After each wash, keep the door open fora while to prevent mould and to let un

5.Clean the dispenser recess with abrush.6.Put back the dispenser in the recess.11.7 Drain pumpRegularly examine the drainpump and make sure that it i

125.When the container is full of water,put the drainage duct back againand empty the container. Do steps 4and 5 again and again until no morewater fl

To clean the water inlet filters:1.Close the water tap.2.Remove the water inlet hose fromthe water tap.3.Clean the filter in the inlet hose witha stif

12. TROUBLESHOOTINGThe start of the appliance does not oc-cur or it stops during operation.First try to find a solution to the problem(refer to the ta

Problem Possible cause Possible solutionThe anti-flood de-vice is on. • Disconnect the appliance.• Close the water tap.• Contact the service centre.T

Problem Possible cause Possible solutionThe appliance fillswith water anddrain immediately.The end of the drainhose is too low.Make sure that the drai

2.Remove the cardboard top.3.Remove the polystyrene packagingmaterials.4.Remove the internal film.5.Open the door. Remove the poly-styrene piece from

127.Remove the polystyrene protectionfrom the bottom.8.Pull up the appliance in vertical po-sition.9.Remove the power supply cable andthe drain hose f

WARNING!Remove all the packaging andthe transit bolts before you installthe appliance.We recommend that you keepthe packaging and the transitbolts for

1. SAFETY INFORMATIONBefore the installation and use of the appliance, careful-ly read the supplied instructions. The manufacturer isnot responsible i

13.4 The inlet hose20O20O20O45O45O45O• Connect the hose to the appliance.Turn the inlet hose only left or right.Loose the ring nut to set it in the co

Water-stop deviceAThe inlet hose has a water stop device.This device prevents water leaks in thehose because of its natural ageing. Thered sector in t

• If the end of the drain hose is this (seethe drawing), you can push it directlyinto the stand pipe.Without the plastic hose guide.• To a sink spigot

13.6 In the interest of the environment• Connect the appliance to the FOULsystem for the drain water. The sew-age works keeps the drain water forthe t

34www.aeg.com

ENGLISH 35

www.aeg.com/shop132932232-A-512012

• If the supply cord is damaged, it must be replaced bythe manufacturer, its service agent or similarly quali-fied persons in order to avoid a hazard.

2.2 UseWARNING!Risk of injury, electrical shock,fire, burns or damage to the ap-pliance.• Use this appliance in a household en-vironment.• Do not chan

Maximum load Cotton 8 kgSpin speed Maximum 1200 rpm1) Connect the water inlet hose to a water tap with a 3/4'' thread.4. PRODUCT DESCRIPTION

4.2 Accessories1 2341SpannerTo remove the transit bolts.2Plastic capsTo close the holes on the rear sideof the cabinet after the removal ofthe transit

• After 5 minutes from the end of thewashing programme. Refer to 'At theend of programme'.5.2 Programme knob 2Turn this knob to set a progra

D • The programme timeWhen the programme starts, the time decreases with steps of 1 mi-nute.• The delay startWhen you press the delay start button, th