Aeg-Electrolux LAV66600 User Manual download pdf (Page 20)

20

E10 appears.

END display flashes 1x,

at the same time an

acoustic signal sounds

1x.

(Problems with water

inflow)

Tap turned off. Turn the tap on.

Filter in the screw

connection of the inlet hose

is blocked.

Turn off the water tap.

Unscrew hose, take out filter

and clean it.

Water tap is blocked with

limescale or faulty.

Check the water tap and

have it repaired if necessary.

The washing machine

vibrates when operating

or is not stable.

The transit packaging has

not been removed.

Removing the transit

packaging.

The screw feet not correctly

adjusted.

Adjust the feet as described

in the installation and

connection instructions.

Washing has not been

spun.

Only a few large items of

washing in the drum.

Always load the drum as full

as possible. Mix large and

small items.

Water is leaking out

underneath the

washing machine.

Screw connection on the

inlet hose is leaking.

Tighten inlet hose.

Drain hose is leaking. Replace drain hose.

Drain pump cover is not

closed properly.

Close cover properly.

Washing was caught in the

door.

Load washing carefully for

the next wash.

Emergency drain hose is

leaking.

Close off emergency drain

hose properly.

Washing water is

foaming excessively. At

the end of the washing

cycle, spin stops.

Probably too much

detergent has been used.

Dose detergent exactly as

instructed by manufacturer.

E20 appears.

ENDdisplay flashes 2x,

at the same time an

acoustic signal sounds

2x.

(Problems with water

outflow)

Kink in drain hose. Remove kink.

Maximum pumping height

of 1m exceeded.

Please contact Customer

Care Department.

Drain pump is blocked.

Switch off appliance. Pull out

mains plug.

Clean drain pump. Remove

foreign bodies from pump

housing.

With connection to sink

outlet: sink outlet is

blocked.

Clean out sink outlet.

Problem Possible cause Remedy

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 35 36

Comments to this Manuals

No comments