AEG Electrolux DD 8625 Specifications download pdf (Page 81)

180°

C-OK!

Fig. 8

Wall unit mounting - Fig. 8-9

Pre-mounting operations (Only for

model DD 8625-8821)

First decide which functioning version is

better for you.

If you decide to use the hood in

exhausting version we suggest to position

the upper section of the chimney so that

the oulet slots are not visible once

installation has ended, on the contrary if

is decided to use the hood in recycling

version BE SURE that the side with slots

is up (see also A-B-C sequence on on

Fig. 8).

 Mark the wall with a centre line, this will

aid mounting procedure (1), position the template so that the mid

line printed on the template matches with the centre line previously

drawn, the lower side of the template corresponds to the lower side

of the hood once mounted (2).

 Drill two holes Ø 8mm and fix the support bracket with two wall

plugs and screws (3). Hang the hood (4) and adjust its position (5-

6).

 From the inside of the hood sign two points for definitive fixing (7).

 Remove the hood (8) and drill two holes Ø 8mm (9), fit two wall

plugs (10).

 Drill two holes Ø 8mm on the upper side close to the ceilling, fit two

wall plugs (11) (In case the hood is to be used in filter version,

mount the deflector F on the chimney support with 2 screws) and fix

the chimney support G with two screws (12).

 Hang the hood again (13) and fix it definitively with two screws (14).

 Fit an exhausting pipe (15) to connect the outlet hole B of the hood

to the outside (Extractor hood) or to the deflector F (Filter version).

 Make electrical connection (16).

 Fix the chimney first up (17a) to the chimney support (17b), then

slide the lower section of the chimney down into the proper housing

on top of the hood (18).

 Only for model DD 8625-8821: Fix the lower section to the hood

with two screws (19).

1 2 ... 76 77 78 79 80 81 82 83 84

No comments

AEG Electrolux DD 8625 Specifications Page 81