Aeg-Electrolux F50870M User Manual download pdf (Page 26)

By removing the machine's worktop, you can install it under a close fitting sink unit or a

pre-existing top, providing the dimensions of the recess correspond to those shown in the

picture.

Proceed as follows:

1. Remove the machine's worktop by un-

screwing the two rear retaining screws,

pull the worktop from the back of the ma-

chine and slide out the front slots, lifting

the worktop.

2. Insert the machine after adjusting the lev-

elling with the adjustable feet.

When inserting the machine, ensure that the water inlet and drain hoses are not kinked or

squashed.

During all operations that involve accessibility to internal components the dishwasher has

to be unplugged.

Be sure that once the appliance has been installed, it is easily accessible for the service

engineer in the event that a repair is required.

If the dishwasher is later used as a free-standing appliance, the original worktop must be

re-mounted.

The plinth on free-standing appliances is not adjustable.

Levelling

Good levelling is essential for correct closure and sealing of the door. When the appliance

is correctly levelled, the door will not catch on either side of the cabinet. If the door does

not close correctly, loosen or tighten the adjustable feet until the machine is perfectly level.

Water connection

Water supply connections

This appliance can be connected to either a hot (max. 60°) or cold water supply.

With a hot water supply you can have a significant reduction of energy consumption. This

however, depends on how the hot water is produced. (We suggest alternative sources of

energy that are more environmentally friendly as e.g. solar or photovoltaic panels and

aeolian).

For making the connection itself, the coupling nut fitted to the machine's supply hose is

designed to screw onto a 3/4" gas thread spout or to a purpose made quick-coupling tap

such as the Press-block.

The water pressure must be within the limits given in the "Technical specifications". Your

local Water Authority will advise you on the average mains pressure in your area.

The water inlet hose must not be kinked, crushed, or entangled when it is being connected.

The dishwasher features fill and drain hoses which can be turned either to the left or the

right to suit the installation by means of the locknut.

The locknut must be correctly fitted to avoid water leaks.

(Attention! NOT all models of dishwashers have fill and drain hoses provided with locknut.

In this case, this kind of facility is not possible). If the machine is connected to new pipes

Water connection

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32

Comments to this Manuals

No comments

Aeg-Electrolux F50870M User Manual Page 26

Comments to this Manuals

Related products and manuals for Dishwashers Aeg-Electrolux F50870M