Aeg-Electrolux S71360KG User Manual download pdf (Page 14)

Problem Possible cause Solution

The appliance has no power.

There is no voltage in the mains

socket.

Connect a different electrical

appliance to the mains socket.

Contact a qualified electrician.

The lamp does not work.

The lamp is in stand-by. Close and open the door.

The lamp is defective. Refer to "Replacing the lamp".

If your appliance is still not working properly after making the above checks, contact the

After Sales Centre.

Replacing the lamp

CAUTION!

Disconnect the plug from the mains socket.

1. Remove the screw from the lamp cover.

2. Pull outwards the hook of the lamp

cover.

3. Remove the lamp cover.

4. Replace the lamp with one of the same

power (the maximum power is shown

on the light bulb cover).

5. Install the lamp cover.

6. Tighten the screw to the lamp cover.

7. Connect the plug to the mains socket.

8. Open the door. Make sure that the light

comes on.

Closing the door

1. Clean the door gaskets.

2. If necessary, adjust the door. Refer to "Installation".

3. If necessary, replace the defective door gaskets. Contact the Service Center.

TECHNICAL DATA

Dimension

Height 1850 mm

Width 595 mm

Depth 648 mm

Rising Time 20 h

The technical information are situated in the rating plate on the internal left side of the

appliance and in the energy label.

Technical data

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 55 56

No comments

Aeg-Electrolux S71360KG User Manual Page 14