AEG Electrolux THYRO-A User Manual download pdf (Page 5)

Technical data

Type voltage ...H1

230V -57%* +10% > 99V

400V -57%* +10% > 172V

500V -57%* +10% > 215V

600V -57%* +10% > 258V

Type voltage ...H RL1 and ...H RLP1 without additional 24V electronics supply

230V -15% +10% 230V -57%* +10% > 99V

400V -15% +10% 400V -57%* +10% > 172V

500V -15% +10% 500V -57%* +10% > 215V

600V -15%*+10% 600V -57%* +10% > 258V

*Additional electronics supply

The additional control voltage supply can be AC or DC (6 W per device / 15VA / not grounded).

Normally the supply of the Master modules is sufficient.

24VAC +10% /-20%; 24VDC +18V to +32V

Mains frequency

All types 47 Hz to 63 Hz;

Max. frequency change 5% per half wave

Load type

Ohmic load

Ohmic load with Rwarm/Rcold ratio up to 6, peak current limiting to Î=3xInom (for ...H RLP1 + HRL 1

in VAR operation)

Transformer load

Thyro-A 2A: symmetrical load

Operating modes

TAKT = Full wave switch principle

VAR = Phase angle principle

QTM = Half wave switch principle (Quick Takt Mode) (only for types 1A)

Setpoint inputs

2 setpoint inputs (SELV, PELV), isolated from the system.

- Setpoint 1: analog setpoint input

Signal ranges:

0(4) - 20mA Ri = approx. 250Ω

0(1) - 5V Ri = approx. 44kΩ

0(2) - 10V Ri = approx. 88kΩ

- Setpoint 2: optional bus interface, connection of higher level PC or automation system.

Control characteristic

Each controller (e.g. temperature controller), with an output signal in the range of 0-20mA / 0-5V / 0-10V, can

be adapted to the power controller.

1 2 3 4 5 6 7 8 9 10

No comments

AEG Electrolux THYRO-A User Manual Page 5