Aeg-Electrolux T7042TK User Manual Page 28

  • Download
  • Add to my manuals
  • Print
  • Page
    / 40
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 27
Machine settings
Setting Implementation
BUZZER
SIGNAL
permanent off
1. Turn the programme selector to any programme.
2.
Press simultaneously the DELICATE SCHON and LONG
ANTI-CREASE KNITTERSCHUTZ PLUS buttons and hold
down for approx. 5 seconds.
3. The buzzer is by default always off. You can use BUZZER
SIGNAL button to activate or deactivate sound but ma-
chine does not memorize your selection.
Water hardness
Water contains, a variable quantity
of limestone and mineral salts of
which quantities vary according to
geographical locations thus vary-
ing its conductivity values.
Relevant variations of the
conductivity of the water compared
to those prefixed by the factory
could slightly influence the residual
humidity of the laundry at the end
of the cycle. Your dryer allows you
to regulate the sensitivity of the
drying sensor based on
conductivity values of the water.
1. Turn the programme selector to any programme.
2.
Press simultaneously the DELICATE SCHON and TIME
ZEITWAHL buttons and hold down for approx. 5 seconds.
The current setting is on the display:
low conductivity <300 micro S/cm
medium conductivity 300-600 micro S/cm
high conductivity >600 micro S/cm
3. Press the START PAUSE button sequentially until you set
desired level.
4. To memorize setting press simultaneously the DELICATE
SCHON and TIME ZEITWAHL buttons or turn knob to OFF
AUS position
Emptying water tank - warning
message permanent off
When using an external drain for
the condensed water.
1. Turn the programme selector to any programme.
2.
Press simultaneously the LONG ANTI-CREASE KNITTER-
SCHUTZ PLUS and TIME ZEITWAHL buttons and hold
down for approx. 5 seconds.
The current setting is on the display:
- led warning is permanently off
- led warning is activated
By default the warning led is activated and is lighting always
at the end of the drying cycle or during the cycle if the water
container is full.
28
Machine settings
Page view 27
1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 39 40

Comments to this Manuals

No comments