Aeg-Electrolux L12843VIT User Manual Page 32

  • Download
  • Add to my manuals
  • Print
  • Page
    / 88
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 31
Problem Possible cause/Solution
There is water on the floor:
Too much detergent or unsuitable detergent (creates too much
foam) has been used.
Reduce the detergent quantity or use another one.
Check whether there are any leaks from one of the inlet hose fit-
tings. It is not always easy to see this as the water runs down the
hose; check to see if it is damp.
Check the water inlet hose connection.
The drain or inlet hose is damaged.
Change it with a new one.
The cap on the emergency emptying hose has not been replaced
or the filter has not been properly screwed in after cleaning ac-
tion.
Refit the cap on the emergency emptying hose or screw the fil-
ter fully in.
Unsatisfactory washing re-
sults:
Too little detergent or unsuitable detergent has been used.
Increase the detergent quantity or use another one.
Stubborn stains have not been treated prior to washing.
Use commercial products to treat the stubborn stains.
The correct temperature was not selected.
Check if you have selected the correct temperature.
Excessive laundry load.
Reduce the laundry load.
The door will not open:
The programme is still running.
Wait the end of washing cycle.
The door lock has not been released.
Wait until the pilot light 10.3 goes off.
There is water in the drum.
Select drain or spin programme to empty out the water.
The machine vibrates is
noisy:
The transit bolts and packing have not been removed.
Check the correct installation of the appliance.
The support feet have not been adjusted
Check the correct levelling of the appliance.
The laundry is not evenly distributed in the drum.
Redistribute the laundry.
Maybe there is very little laundry in the drum.
Load more laundry.
32 What to do if…
Page view 31
1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 87 88

Comments to this Manuals

No comments