Aeg-Electrolux L61470WDBI User Manual download pdf (Page 18)

The water must be emptied out before

opening the door. During this time the

drum continues to turn at regular inter-

vals until water drain.

Follow the below instructions to empty

out the water:

• Turn the programme selector dial to

• Set the DRAIN or SPIN programme

• Reduce the spin speed, if needed

• Press the button 8

• When the programme has finished the

display shows a blinking

. The pilot

light C goes off. The door can be

opened.

Turn the programme selector dial to

to switch the machine off.

Remove the laundry from the drum and

carefully check that the drum is empty. If

you do not intend to carry out another

wash, close the water tap. Leave the

door open to prevent the formation of

mildew and unpleasant smells.

Stand by : once the programme has fin-

ished after a few minutes the energy sav-

ing system will be enabled. The bright-

ness of the display is reduced. By press-

ing any button the appliance will come

out of the energy saving status.

10. DAILY USE - DRYING

10.1 Drying only

The recommended load size is 3 kg for

cottons and linen, and 2 kg for synthetic

items.

It is also possible to dry up to 4

kg of cotton items (see the «Dry-

ing Programme » table).

The water tap must be open and the

drain hose must be positioned in the

sink or connected to the drain pipe.

1.

Load the laundry.

2.

Select a spin cycle at the maximum

spin speed allowed for the type of

laundry in order to obtain the best

drying performances.

3.

Set the drying programme for Cot-

tons or Synthetic in the Drying sec-

tor of the programme dial.

4.

Press button 6 to set the drying

time. Press this button again and

again until the time you want ap-

pears on the display.

For Cottons you can set a drying

time from 10 minutes to 250 minutes

(hours 4.10).

For Synthetic you can select a drying

time from 10 minutes to 130 minutes

(hours 2.10).

Every time you press this button the

drying time increases by 5 minutes.

Note! The programme time will au-

tomatically increase by a few mi-

nutes.

5.

Press button 8 to start the pro-

gramme.

After the programme has started,

the time remaining is updated every

minute.

If you set only 10 minutes of dry-

ing phase with the timed drying

button, the appliance performs

only a cooling phase.

6.

At the end of the drying pro-

gramme, some acoustic signals

sound. A blinking

appears on the

display.

The pilot light B, and C and the light

of the button 8 go off.

At this point, begins an anti-crease

phase, which lasts for about 10 mi-

nutes. During this time the light C is

on. The door cannot be opened.

If you need to open the door be-

fore or during the anti-crease

phase or to interrupt it, press any

button or turn the programme

dial to any programme position

(except O.

The door can be opened after

some minutes. (In any case do

not try to open the door if it is

locked!) .

18

www.aeg.com

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 39 40

Comments to this Manuals

No comments