Aeg-Electrolux L61470WDBI User Manual download pdf (Page 26)

To clean the water inlet filters:

1.

Close the water tap.

2.

Remove the water inlet hose from the

water tap.

3.

Clean the filter in the inlet hose with a

stiff brush.

4.

Remove the inlet hose behind the

appliance.

5.

Clean the filter in the valve with a stiff

brush or a towel.

45°

20°

6.

Install again the inlet hose. Make sure

that the couplings are tight to pre-

vent leakages.

7.

Open the water tap.

EMERGENCY EMPTYING OUT

If the water is not discharged, proceed as

follows to empty out the appliance:

1.

pull out the plug from the power

socket;

2.

close the water tap;

3.

if necessary, wait until the water has

cooled down;

4.

place a bowl on the floor;

5.

place the end of the emergency emp-

tying hose into the bowl;

6.

Remove its cap. The water should

drain by gravity into the bowl. When

the bowl is full, put the cap back on

the hose. Empty the bowl;

Repeat the procedure until water

stops flowing out;

7.

clean the pump if necessary as previ-

ously described;

8.

replace the emergency emptying

hose in its seat after having plugged

it;

9.

screw the pump again.

FROST PRECAUTIONS

If the machine is installed in a place where

the temperature could drop below 0°C,

proceed as follows:

1.

close the water tap;

2.

unscrew the water inlet hose from the

tap;

3.

place the end of the emergency emp-

tying hose and that of the inlet hose

in a bowl placed on the floor. Let wa-

ter drain out;

4.

screw the water inlet hose back on;

5.

put the cap on the emergency empty-

ing hose again;

6.

reposition the emergency emptying

hose.

By doing this, any water remaining in the

machine is removed, avoiding ice forming

and consequently damage to the appli-

ance.

When you use the machine again, make

sure that the ambient temperature is

above 0°C.

26

www.aeg.com

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 39 40

Comments to this Manuals

No comments