Aeg-Electrolux L64840 User Manual download pdf (Page 41)

3. Set the hose correctly by loosening the ring nut.

After positioning the inlet hose, be sure to tighten

the ring nut again to prevent leaks.

4. Connect the hose to a tap with a 3/4” thread.

Always use the hose supplied with the appliance.

Water-stop device

The inlet hose is provided with a water stop device,

which protects against damage caused by water leaks in

the hose which could develop due to natural ageing of

the hose. This fault is shown by a red sector in the

window “A”. Should this occur, turn the water tap off

and refer to your Service Centre to replace the hose.

Water drainage

The end of the drain hose can be positioned in three ways:

Hooked over the edge of a sink using the plastic hose guide supplied

with the machine.

In this case, make sure the end cannot come unhooked when the machine is

emptying.

This could be done by tying it to the tap with a piece

of string or attaching it to the wall.

In a sink drain pipe branch. This branch must be

above the trap so that the bend is at least 60 cm above

the ground.

Directly into a drain pipe at a height of not less

than 60 cm and not more than 90 cm.

The end of the drain hose must always be ventilated,

i.e. the inside diameter of the drain pipe must be larg-

er than the outside diameter of the drain hose.

The drain hose must not be kinked.

Installation

352

132972841 gb.qxd 12/10/2009 11.58 Pagina 41

1 2 ... 36 37 38 39 40 41 42 43 44

No comments

Aeg-Electrolux L64840 User Manual Page 41