Aeg-Electrolux L74950M3 User Manual

LAVAMAT 74950 M3ENWASHING MACHINE USER MANUAL

FIRST USE• Ensure that the electrical and water connections comply with the installation instruc-tions.• Remove the polystyrene block and any material

DAILY USELoad the laundry1. Open the door by carefully pulling thedoor handle outwards. Place the laundryin the drum, one item at a time, shakingthem

2. If required, pour fabric softener into thecompartment marked (the amountused must not exceed the MAX mark inthe drawer).Close the drawer gently.Tu

Select the spin speed, NIGHT CYCLE or RINSE HOLD option (button 3)When the required programme has been selected, your appliance automatically proposes

This option is recommended for heavily soiled laundry.STAIN optionSelect this option to treat heavily soiled or stained laundry with stain remover (ex

Select the DELAY START (button 8)Before you start the programme, if you wish to delay the start, press the button repeated-ly, to select the desired d

Opening the door after the programme has startedWhen the machine is working and throughout the delay time the door is locked. If, for anyreason, you w

WASHING PROGRAMMESProgramme - Maximum and Minimum Tempera-ture - Cycle Description - Maximum Fabrics Load -Type of LaundryOptionsDetergent Com-partmen

Programme - Maximum and Minimum Tempera-ture - Cycle Description - Maximum Fabrics Load -Type of LaundryOptionsDetergent Com-partmentSYNTHETICS60° - C

Programme - Maximum and Minimum Tempera-ture - Cycle Description - Maximum Fabrics Load -Type of LaundryOptionsDetergent Com-partmentSPINDrain and lon

FOR PERFECT RESULTSThank you for choosing this AEG product. We have created it to give youimpeccable performance for many years, with innovative techn

Programme - Maximum and Minimum Tempera-ture - Cycle Description - Maximum Fabrics Load -Type of LaundryOptionsDetergent Com-partmentSPORT INTENSIVE40

Programme - Maximum and Minimum Tempera-ture - Cycle Description - Maximum Fabrics Load -Type of LaundryOptionsDetergent Com-partmentCOTTON ECONOMY60°

Dried grease stains: moisten with turpentine, lay the garment on a soft surface and dabthe stain with the fingertips and a cotton cloth.Rust: oxalic a

• large amounts of foam form during washing.Degrees of water hardnessWater hardness is classified in so-called “degrees” of hardness. Information on h

2. Remove the conditioner insert from themiddle compartment.3. Clean all parts with water.4. Put the conditioner insert in as far as itwill go, so tha

• the appliance makes an unusual noise during draining due to objects such as safety pins,coins etc. blocking the pump;• a problem with water draining

8. Remove foreign bodies and fluff fromthe filter seat and from the pump im-peller.9. Check carefully whether the pump im-peller rotates (it rotates j

5. Unscrew the hose from the machine.Keep a towel nearby because some wa-ter may flow.6. Clean the filter in the valve with a stiffbrush or with the p

5. place a bowl on the floor and place the end of the emergency emptying hose into thebowl. Remove its cap. The water should drain by gravity into the

Problem Possible cause/SolutionThe machine does not fill:The water tap is closed. • Open the water tap.The inlet hose is squashed or kinked. • Check t

CONTENTS4 Safety information6 Product description7 Control panel10 First use10 Personalization11 Daily use17 Washing programmes21 Helpful hints and ti

Problem Possible cause/SolutionUnsatisfactory washing results:Too little detergent or unsuitable detergent hasbeen used.• Increase the detergent quant

Problem Possible cause/SolutionThe machine makes an unusual noise:The machine is fitted with a type of motorwhich makes an unusual noise compared with

CONSUMPTION VALUESProgramme1)Energy consumption(kWh)2)Water consumption(litre)2)White Cottons 95 °C 2.5 62Cottons 60 °C 1.7 63Cottons 40 °C 0.97 62Syn

2. Remove the power supply cable and thedraining hose from the hose holders onthe rear of the appliance.3. Unscrew the three bolts using the keysuppli

5. Open the porthole, take out the inlethose from the drum and remove thepolystyrene block fitted on the doorseal.6. Fill the smaller upper hole and t

Please ensure that when the appliance is installed, it is easily accessible for the engineer inthe event of a breakdown.Carefully level by screwing th

Water-stop deviceThe inlet hose is provided with a water stop de-vice, which protects against damage caused bywater leaks in the hose which could deve

The drain hose may be extended to a maximum of 4 metres. An additional drain hose andjoining piece is available from your local Service Centre.ELECTRI

Packaging materialsThe materials marked with the symbol are recyclable.>PE<=polyethylene>PS<=polystyrene>PP<=polypropyleneThis mea

39

SAFETY INFORMATIONRead carefully & keep for future reference.• The safety of Your appliance complies with the industry standards and with legal r

www.aeg.com/shop 132928050-A-452011

• After having installed the appliance, check that it is not standing on the inlet and drainhose and the worktop is not pressing the electrical supply

• Make sure that children or pets do not climbinto the drum. To prevent children or petsbecoming trapped inside the drum the ma-chine incorporates a s

Detergent dispenser drawer Compartment for detergent used for prewash. The prewash detergent is added at thebeginning of the wash programme. Compartme

3SPIN reduction button4OPTION button5OK button6TIME SAVING button7START/PAUSE button8DELAY START button9DisplayTable of SymbolsProgramme dialCottons/L

• During a washing cycle, a black line blinks under the washing phase symbol of the run-ning programme. At the end of each washing phase, the line und