EN User ManualWashing MachineL 87495 XFL
Lthe Stain symbol comes on when you activate the function.The Prewash symbol comes on when this function is activated.The indicator bar is not fully f
ProgrammeTemperature rangeMaximum loadReference spinspeedProgramme description(Type of load and soil level)Spülen 4)Cold9 kg1400 rpmTo rinse and spin
ProgrammeTemperature rangeMaximum loadReference spinspeedProgramme description(Type of load and soil level) Glätten1.5 kg Steam programme for syntheti
ProgrammeFlecken/Vorwäsche 1)Extra Spülen 2)Zeit Sparen 3)ZeitvorwahlWolle/Seide Daunen 4) Anti-Allergie Schleudern
At the start of the programme, the display shows the programme dura-tion for the maximum load capacity.During the washing phase the programme duration
7. OPTIONS7.1 Start/Pause Press button Start/Pause to start orinterrupt a programme.7.2 Zeitvorwahl With this option you can delay the startof a progr
• The appliance has a malfunction.To deactivate/activate the acousticsignals, press Flecken/Vorw. and ExtraSpülen at the same time for 6 seconds.If yo
CAUTION!Make sure that no laundrystays between the seal andthe door. There is a risk ofwater leakage or damage tothe laundry.Washing heavily oiled,gre
With the flap in theposition DOWN:• Do not usegelatinous or thickliquid detergents.• Do not put moreliquid detergent thanthe limit shown on inthe flap
Before starting the newprogramme the appliancecould drain the water. In thiscase, make sure that thedetergent is still in thedetergent compartment, if
CONTENTS1. SAFETY INFORMATION...32. SAFETY INSTRUCTIONS...
Press the button Auto Off to activatethe appliance again.The display shows the end of the lastset programme.Turn the programme knob to set anew cycle.
• If your appliance does not have thedetergent dispenser with the flapdevice, add the liquid detergents witha dosing ball (supplied by thedetergent&ap
2. Start a short programme for cotton atthe maximum temperature with asmall quantity of detergent.12.6 Cleaning the detergent dispenser1.122.3. 4.12.7
1.122.180°3.124.125. 6.7.128.12ENGLISH 23
Always keep a rag nearby todry up any water spillage.Make sure that the impellerof the pump can rotate. If itdoes not rotate, contact theAuthorised Se
WARNING!Make sure that thetemperature is higher than 0°C before you use theappliance again.The manufacturer is notresponsible for damagescaused by low
Problem Possible solutionThe appliance does notfill with water properly.• Make sure that the water tap is open.• Make sure that the pressure of the wa
Problem Possible solutionYou cannot open the ap-pliance door.• Make sure that the washing programme is finished.• Set the drain or the spin option if
Make sure that the waterlevel inside the drum is nottoo high. If necessary,proceed with anemergency drain (refer to«Emergency drain» in«Care and clean
Model L87495XFL, PNC914531258Rated capacity in kg 9Energy efficiency class A+++Energy consumption in kWh per year, based on 220standard washing cycles
1. SAFETY INFORMATIONBefore the installation and use of the appliance,carefully read the supplied instructions. Themanufacturer is not responsible f
Airborne acoustical noise emission in db(A) spinning 73Built in appliance Y/N NoThe information given in the chart above is compliant with the EU Comm
ENGLISH 31
www.aeg.com/shop132928974-A-402018
– by clients in hotels, motels, bed & breakfast andother residential type environments;– areas for communal use in blocks of flats or inlaunderett
• The floor area on which the applianceis to be installed must be flat, stable,heat resistant and clean.• Make sure that there is air circulationbetwe
2.6 DisposalWARNING!Risk of injury or suffocation.• Disconnect the appliance from themains electrical and water supplies.• Cut off the mains electrica
4. CONTROL PANEL4.1 Control panel description.pmeTU./Min.Start/Pause-tieZlhawrovZeitnerapSFlecken/.wroVartxEnelüpSWolle/SeideWWKoch/BuntExtra LeisePfl
BSpin speed of the set programmeNo Spin symbol1)Rinse hold symbol1) Only available for SPIN/DRAIN programme.CThe phase symbolsWhen a programme is set,
HProgramme timeWhen the programme starts, the programme time decreases withsteps of 1 minute.Delay startWhen you press the delay start button, the dis
Comments to this Manuals