L 87485 FLL 87685 FLEN User manual
The indicator bar is fully filled when you set to the maxi-mum number of rinses.LThe Stain symbol comes on when you activate the function.The Prewash
5.11 Acoustic signals functionYou can hear the acoustic signals when:• You activate the appliance.• You deactivate the appliance.• You press the butto
ProgrammeTemperatureType of loadMax. weight ofloadCycle descrip-tionFunctionsLeichtbügeln4)60 - 0°Synthetic fabricswith normal soil.max. load 4 kgWash
ProgrammeTemperatureType of loadMax. weight ofloadCycle descrip-tionFunctionsSpülen0°All fabrics.max. load 8 kgOne rinse withadditives.Spin phaseSPIN
Steam AuffrischenThis cycle removes odours from thelaundrySteam does not remove ani-mal odours.Cotton and synthet-ic itemsup to 1.5 KgSteam GlättenThi
The data of this table are approximate. Different causes can change the da-ta: the quantity and type of laundry, the water and ambient temperature.Pro
2.Connect the mains plug to the mainssocket.3.Press button 1 to activate the ap-pliance.4.Put the laundry in the appliance.5.Use the correct quantity
Liquid additives compartment (fabric conditioner, starch).Put the product in the compartment before you start the pro-gramme.This is the maximum level
5.Measure out the detergent and thefabric conditioner.6.Carefully close the detergent dis-penser. Make sure that the flapdoes not cause a blockage whe
To open the appliance door:1.Press button 4 . The door locksymbol in the display goes off.2.Open the appliance door.3.Close the appliance door and pre
CONTENTS1. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32. SAFETY
11. HELPFUL HINTS AND TIPS11.1 The laundry load• Divide the laundry in: white, coloured,synthetics, delicates and wool.• Obey the washing instructions
Water hardness tableLevel TypeWater hardness°dH °T.H. mmol/l Clarke1 soft 0-7 0-15 0-1.5 0-92 medium 8-14 16-25 1.6-2.5 10-163 hard 15-21 26-37 2.6-3.
12.6 Detergent dispenserTo clean the dispenser:121.Press the lever.2.Pull the dispenser out.3.Remove the top part of the liquidadditive compartment.4.
To clean the drain pump:1.Open the drain pump door.2.Pull the flap out to remove it.3.Put a container below the recess ofthe drain pump to collect the
129.Clean the filter under the water tapand put it back in the pump into thespecial guides.10.Make sure that you tighten correctlythe filter to preven
Put the drainage duct back and close thedrain pump flap.When you drain the water with the emer-gency drain procedure, you must acti-vate again the dra
Problem Possible cause Possible solutionThe appliancedoes not drain thewater.The water drain hose isdamaged.Make sure that the water drainhose has no
Problem Possible cause Possible solution Leakages from the drainpump.Make sure that the drain pumpfilter is tight. The water drain hose isdamaged.Ma
14.2 Unpacking1.Use the gloves. Remove the externalfilm. If necessary, use a cutter.2.Remove the cardboard top.3.Remove the polystyrene packagingmater
6.Put one of the polystyrene packag-ing elements on the floor behindthe appliance. Carefully put downthe appliance with the rear side onit. Make sure
1. SAFETY INFORMATIONBefore the installation and use of the appliance, careful-ly read the supplied instructions. The manufacturer isnot responsible i
12.Put the plastic caps in the holes.You can find these caps in the usermanual bag.WARNING!Remove all the packaging andthe transit bolts before you in
14.4 The inlet hose20O20O20O45O45O45O• Connect the hose to the appliance.Turn the inlet hose only left or right.Loose the ring nut to set it in the co
With the plastic hose guide. • On the edge of a sink.• Make sure that the plastic guide can-not move when the appliance drains.Attach the guide to the
You can extend the drain hose tomaximum 400 cm. Contact theservice centre for the other drainhose and the extension.15. ENVIRONMENT CONCERNSRecycle th
34www.aeg.com
ENGLISH 35
www.aeg.com/shop132940523-B-352012
• If the supply cord is damaged, it must be replaced bythe manufacturer, its service agent or similarly quali-fied persons in order to avoid a hazard.
Water connection• Make sure not to cause damage to thewater hoses.• The appliance is to be connected tothe water mains using the new sup-plied hose-se
Spin speed Maximum 1400 rpm (L 87485 FL)1600 rpm (L 87685 FL)1) Connect the water inlet hose to a water tap with a 3/4'' thread.4. PRODUCT D
5. CONTROL PANELBaumwolle Eco.pmeTU./Min.Start/Pause-tieZlhawrovZeitnerapSFlecken/.wroVartxEnelüpSWolle/SeideWWKoch/BuntExtra LeisePflegeleichtLeicht
5.3 Display 3A HJKLC D E F GBIThe display shows:AThe temperature of the set programmeCold waterBThe spin speed of the set programmeNo Spin symbol1)Rin
FYou cannot open the appliance door when the symbol ison.You can open the door only when the symbol goes off.If the programme is completed but the sym
Comments to this Manuals