Aeg-Electrolux LAVBELLA3051 User Manual download pdf (Page 17)

Interrupting a programme/adding washing

Interrupting a programme

• A washing programme can be interrupted at any time by pressing the

START/PAUSE button. It is then re-started by pressing the START/

PAUSE button again.

• To stop the washing machine before the programme has ended, turn

the programme knob to OFF. Important! Be careful if there is water

in the appliance!

Adding washing

It is possible to add washing, as long as the DOOR light is lit green.

1. Press the START/PAUSE button. The door can be opened.

2. Shut the door and press the START/PAUSE button again. The pro-

gramme continues.

End of the wash cycle/removing the washing

At the end of the programme, END lights up on the programme

progress display. The door can be opened as soon as the DOOR indicator

is lit green.

1. Open the loading door and remove the washing.

2. Turn the programme knob to OFF.

3. After washing, pull out the detergent drawer a little to enable it to dry

out. Keep the loading door very slightly open so that the washing ma-

chine can air.

If RINSE HOLD has been selected:

After the rinse hold, END lights up on the programme progress display.

The water must first be drained:

– Either turn the programme knob to OFF, then to DRAIN and press the

START/PAUSE button (the water is drained without spinning),

– or turn the programme knob to OFF and then to SPIN. Change the

spin speed if necessary and press the START/PAUSE button (the water

is drained and the washing spun).

Overdosing

3 If the OVERDOSING indicator is lit, too much detergent was used in the

previous programme. The next time you wash, observe the dosing rec-

ommendations of the detergent manufacturer and the load sizes.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 39 40

No comments

Aeg-Electrolux LAVBELLA3051 User Manual Page 17