LAVAMAT LN 79680A3LAVAMAT LN 79689A3User manual Washing Machine
2. If required, pour fabric softener into thecompartment marked (the amountused must not exceed the MAX mark inthe drawer).Close the drawer gently.Tu
Select the spin speed, NIGHT CYCLE or RINSE HOLD option (button 3)When the required programme has been selected, your appliance automatically proposes
This option is recommended for heavily soiled laundry.STAIN optionSelect this option to treat heavily soiled or stained laundry with stain remover (ex
Select the DELAY START (button 8)Before you start the programme, if you wish to delay the start, press the button repeat-edly, to select the desired d
Opening the door after the programme has startedWhen the machine is working and throughout the delay time the door is locked. If, for anyreason, you w
WASHING PROGRAMMESProgrammeMaximum and Minimum TemperatureCycle DescriptionMaximum Fabrics LoadType of LaundryOptionsDetergentCompartmentCOTTON95°- Co
ProgrammeMaximum and Minimum TemperatureCycle DescriptionMaximum Fabrics LoadType of LaundryOptionsDetergentCompartmentSYNTHETICS60°- ColdMain wash -
ProgrammeMaximum and Minimum TemperatureCycle DescriptionMaximum Fabrics LoadType of LaundryOptionsDetergentCompartmentDRAINDraining of waterMax. load
ProgrammeMaximum and Minimum TemperatureCycle DescriptionMaximum Fabrics LoadType of LaundryOptionsDetergentCompartmentSPORT JACKETS40° - ColdMain was
ProgrammeMaximum and Minimum TemperatureCycle DescriptionMaximum Fabrics LoadType of LaundryOptionsDetergentCompartmentCOTTON ECONOMY60°Main wash - Ri
Thank you for choosing one of our high-quality products.To ensure optimal and regular performance of your appliance please read thisinstruction manual
Dried grease stains: moisten with turpentine, lay the garment on a soft surface and dabthe stain with the fingertips and a cotton cloth.Rust: oxalic a
Degrees of water hardnessWater hardness is classified in so-called “degrees” of hardness. Information on hardness ofthe water in your area can be obta
2. Remove the conditioner insert from themiddle compartment.3. Clean all parts with water.4. Put the conditioner insert in as far as itwill go, so tha
• the appliance makes an unusual noise during draining due to objects such as safety pins,coins etc. blocking the pump;• a problem with water draining
8. Remove foreign bodies and fluff fromthe filter seat and from the pump im-peller.9. Check carefully whether the pump im-peller rotates (it rotates j
5. Unscrew the hose from the machine.Keep a towel nearby because some wa-ter may flow.6. Clean the filter in the valve with a stiffbrush or with the p
5. place a bowl on the floor and place the end of the emergency emptying hose into thebowl. Remove its cap. The water should drain by gravity into the
Problem Possible cause/SolutionThe machine does not fill:The water tap is closed. • Open the water tap.The inlet hose is squashed or kinked. • Check t
Problem Possible cause/SolutionUnsatisfactory washing results:Too little detergent or unsuitable detergent hasbeen used.• Increase the detergent quant
Problem Possible cause/SolutionThe machine makes an unusual noise:The machine is fitted with a type of motorwhich makes an unusual noise compared with
Water drainage 34ELECTRICAL CONNECTION 35ENVIRONMENT CONCERNS 36Packaging materials 36Ecological hints 36Subject to change without noticeOPE
CONSUMPTION VALUESProgramme1)Energy consumption (KWh)2)Water consumption (li-tre)2)White Cottons 95 °C 2.5 65Cottons 60 °C 1.7 63Cottons 40 °C 1.0 62S
1. After removing all the packaging, care-fully lay machine on it’s back to removethe polystyrene base from the bottom.2. Remove the power supply cabl
4. Slide out the relevant plastic spacers.5. Open the porthole, take out the inlethose from the drum and remove thepolystyrene block fitted on the doo
Positioning and levellingInstall the machine on a flat hard floor.Make sure that air circulation around the machineis not impeded by carpets, rugs etc
3. Set the hose correctly by loosening thering nut. After positioning the inlethose, be sure to tighten the ring nutagain to prevent leaks.4. Connect
This could be done by tying it to the tapwith a piece of string or attaching it tothe wall.2. In a sink drain pipe branch. Thisbranch must be above th
WARNING!Should the appliance power supply cable need to be replaced, this must be carriedout by a Service Centre.ENVIRONMENT CONCERNSThe symbol on t
37
38
Installation• This appliance is heavy. Care should be taken when moving it.• When unpacking the appliance, check that it is not damaged. If in doubt,
www.aeg.com/shop 132943471-A-282011
• Make sure that children or pets do not climbinside the drum. To prevent children or petsbecoming trapped inside the drum the ma-chine incorporates a
Detergent dispenser drawer Compartment for detergent used for prewash. The prewash detergent is added at thebeginning of the wash programme. Compartme
3 SPIN reduction button4 OPTIONS button5 OK button6 TIME SAVING button7 START/PAUSE button8 DELAY START button9 DisplaySymbols: Handwash; Child Lock.D
– After selecting a programme, the duration is displayed in hours and minutes (for ex-ample . The duration is calculated automatically on the basis o
This function remains able also when the washing machine is not working.To enable (or disable) this option press simultaneously for about 6 seconds bu
Comments to this Manuals