AEG Electrolux EBGL70 User Manual download pdf (Page 24)

A

A

CAUTION!

Be careful when you remove the

door from the appliance. The door

is heavy. There is a risk of injury or

damage to the appliance.

Removing the door

1.

Open the door as far as it goes.

2.

Fully press the clamping levers (A) on

the two door hinges.

45°

3.

Close the door until it is at an angle of

approximately 45°.

4.

Hold the door with one hand on each

side and pull it away from the appli-

ance at an upwards angle.

Put the door with the outer side

down on a soft and level surface to

prevent scratches.

Installing the door

To install the door do the above steps in

the opposite sequence.

LAMP

WARNING!

There is a risk of electrical shock.

The lamp and the lamp glass cover

can be hot.

Before you change the lamp:

• Deactivate the appliance.

• Remove the fuses from the fuse box or

deactivate the circuit breaker.

CAUTION!

Put a cloth on the bottom of the in-

terior of the appliance. It prevents

damage to the lamp glass cover

and the cavity.

Always use the same lamp type.

Replacing the top lamp

1.

Turn the lamp glass cover counter-

clockwise to remove it.

2.

Remove the metal ring and clean the

glass cover.

3.

Replace the lamp with a suitable 300

°C heat-resistant lamp.

4.

Attach the metal ring to the glass cov-

er.

5.

Install the glass cover.

Replacing the side lamp

1.

Remove the left shelf support.

2.

Use a Torx 20 screwdriver to remove

the cover.

3.

Remove and clean the metal frame

and the seal.

4.

Replace the lamp with a suitable 300

°C heat-resistant lamp.

5.

Install the metal frame and the seal.

Tighten the screws.

6.

Install the left shelf support.

24

www.electrolux.com

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30 31 32

Comments to this Manuals

No comments