Aeg-Electrolux C41022GN-M User Manual download pdf (Page 11)

Instructions for the installer

3.3.3 Replacing the electric cable

To replace the electric cable, it is necessary to access the terminal board. It is located on the back

of the appliance, at the top left, as shown in the figure.

To replace the cable, proceed as follows:

x open the terminal board box;

x unscrew the screw A that locks the cable;

x loosen the screw contacts and replace the cable

with one of the same length that corresponds to the

specifications in the table in section “3.3.1 Electric

power cable section”;

x the "yellow-green" earth wire must be connected to

the terminal

and must be approximately 20 mm

longer than the line cables;

x the neutral "blue" wire must be connected to the

terminal marked with the letter N;

x the line wire must be connected to the terminal

marked with the letter L.

3.4 Power consumption of the vitroceramic hob

The vitroceramic hob has different power consumptions depending on the type of heating element

used. The diagram shows the values of the power consumed.

In the envisaged cases, the first numeric value refers to the total power, whereas the value that

follows the symbol "/" refers to the inside diameter, with the exception of the central heating

element, whose value that follows "/" refers to the outer diameter.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

No comments

Aeg-Electrolux C41022GN-M User Manual Page 11