AEG Electrolux EWT 1342 User Manual download pdf (Page 17)

3. INSTALLATION

3.1. Unpacking

Packing used to protect internal parts of the

washing machine during transport must be

removed before the washing machine is put

into service for the first time.

Remove all packing from the

washing machine. Tilt the washing

machine sideways and then remo-

ve the packing under the motor,

and straighten the washing machi-

ne.

Tilt the washing machine back-

wards, rotate it by a quarter of a

turn on one of its corner to remove

the transport base.

Open the washing machine lid and

remove the immobilization packing

and plastic films.

Close the lid.

Use a 10 mm spanner to remove

the two screws and spacers at the

back.

You can now see the openings that

must be closed with the caches in

the pack attached to the washing

machine; do not forget to fold down

the central capsule.

Make sure that you have removed

all these parts from your washing

machine and keep them so that

you can use them again if you need

them for future transport.

If you want to keep your washing

machine aligned with the adjacent

furniture, you can cut the pipe sup-

port strip at the back of your

washing machine. Leave the two

side closers in place.

3.2. Position

Put the washing machine on a flat hard floor in a well ven-

tilated room.

Make sure that your washing machine does not touch the

wall or any other furniture in the room.

3.3. Moving your washing machine

If you want to move your washing

machine, lift it onto its rollers by

pulling the lever at the bottom of

the washing machine all the way to

the left. When you have put your

washing machine into the required

location, put the lever back into its

initial position.

3.4. Leveling

Precise leveling will prevent vibrations, noise and move-

ments of the washing machine during operation.

Make the washing machine level

by adjusting the leveling screw

that is too short.

Unscrew the stand and locking

collar assembly (lift the washing

machine if necessary).

When the washing machine is sta-

ble, maintain the stand on the

ground and turn the locking collar

as far as posible.

3.5. Water inlet

This device (the aqua-control hose)

protects against water damage.

The water inlet hose may perish

due to natural wear : if this

happens, this device stops water

entering the appliance.

The fault is shown when a red mark appears in the window

«A». Turn off the water inlet tap and call the After Sales

Department.

Please install the water inlet hose onto the back of your

washing machine :

Downloaded From WashingMachine-Manual.com Manuals

1 2 ... 12 13 14 15 16 17 18 19

Comments to this Manuals

No comments

AEG Electrolux EWT 1342 User Manual Page 17

Comments to this Manuals

Related products and manuals for Washing machines AEG Electrolux EWT 1342