Aeg-Electrolux DD8891-M/A User Manual

DD 8891Cooker HoodOperating and Installation Instructions

10Charcoal filter• The charcoal filter should only be used if you want to use the hood inthe recirculation function.• To do this you will need an orig

11 Warning• Failure to observe the instructions on cleaning the unit and changingthe filters will cause a fire hazard. You are therefore stronglyrecom

12Something Not WorkingIf your appliance fails to work properly please carry out the followingchecks. Symptom SolutionThe cooker hood Check that: The

13Technical SpecificationsDimensions (in cm):Height 72-114Width 89,8Depth 45Maximum absorbed power (W): 215Motor (W): 175Lighting (W): 2 x 20Length of

14Wall unit mounting - Fig. 6• Mark the wall with a centre line, this will aid mounting procedure (1),position the template so that the mid line print

15Fig. 617b17b4-134-131231111121517a17a6516BGH8818F91014791014756

AEG Hausgeräte GmbHPostfach 1036D-90327 Nürnberghttp://www.aeg.hausgeraete.de© Copyright by AEGLI2U8A Ed. 02/06 From the Electrolux Group.

2ContentsSafety warnings ... 3For the user ...

3 Safety warningsFor the user• The cooker hood is designed to extract unpleasant odours fromthe kitchen, it will not extract steam.• Always cover li

4For the installer• When used as an extractor unit, the hood must be fitted with a150mm diameter duct.• When installing the hood, make sure you respec

5- short and straight outlet ducting- keep bends in outlet ducting to a minimum- never install the ducts with an acute angle, they must always followa

6Fig. 1ADescription of the Appliance• The cooker hood is designed to extract unpleasant odours fromthe kitchen, it will not extract steam.• The hood i

7Control Panel• Best results are obtained by using a low speed for normal conditionsand a high speed when odours are more concentrated.Turn the hood o

8Grease and charcoal filter maintenanceindicatorThis hood is fitted with a device that indicates when it is necessary toclean the grease filter or the

9Maintenance and Care• The hood must always be disconnected from the electricitysupply before beginning any maintenance work.Cleaning the hood• Clean