AEG Electrolux DK 9990 Specifications download pdf (Page 10)

Control device for grease and charcoal filters

DK 9660 - DK 9690 - DK 9960 - DK 9990 - HC 5690

This hood is fitted with a device that signals when it is necessary to

clean the grease filter or the charcoal filter (if the hood is used in the

recirculation version with a charcoal filter).

On delivery, the hood is not supplied with a charcoal filter, so the

saturation indicator will be disabled.

If the hood is to be used with a charcoal filter, the saturation

indicator light must be enabled as follows:

Pressing keys B and D simultaneously for three seconds, LED F lights

up and begins to flash the 1

speed led. After 1 second the 2

speed

led also flashes and the system emits a sound signal (-Beep-) to

indicate setting taking place.

To remove the charcoal filter signal press push buttons B and D

simultaneously for 3 seconds. LED F lights up and begins to flash the

speed led (grease filter) and the 2

speed led. After 1 second, only

the 1

speed led continues to flash. The system emits a sound signal

(-Beep-) to indicate setting taking place.

Grease filter LED

The 1

speed led (+ led F) flashes, when it is time to clean the grease

filter.

Always comply with the maintenance instructions for the grease filter.

Charcoal filter LED

The 2

speed led (+ led F) flashes, when the charcoal filter needs to

be cleaned or replaced.

Resetting the saturation indicator

After cleaning or replacing the filters, press button 1 for 3 seconds until

the 1

speed led or the second speed led stops flashing.

The F LED also turns off..

Warning! The resetting of the saturation indicator MUST be done in

stand-by, never disconnect the hood from the mains.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

No comments

AEG Electrolux DK 9990 Specifications Page 10