Aeg-Electrolux F65010VI User Manual download pdf (Page 80)

3. Press the On/Off button. The dishwasher must be in setting mode.

4. Press the button corresponding to the required programme (see "Washing programmes"

chart). Close the dishwasher door, the programme starts automatically.

Setting and starting the programme with delay start

1. After having selected the washing programme, press the delay start button until the

number of hours for the delay start appear in the digital display. The start of the selected

washing programme can be delayed for between 1 and 19 hours.

2. Close the dishwasher door, the countdown starts automatically.

3. The countdown will decrease with steps of 1 hour.

4. The opening of the door will interrupt the countdown. Close the door; the countdown

will continue from the point at which it was interrupted.

5. Once the delay start has elapsed the programme will start automatically.

Once the washing programme has started, a point-shaped optical signal appears on the

floor beneath the dishwasher's door.

This optical signal will remain illuminated for all the duration of the washing programme.

If the appliance has been installed higher up with a furniture door mounted flush, the

optical signal will be no longer visible.

WARNING!

Interrupt or cancel a washing programme in progress ONLY if it’s absolutely nec-

essary. Attention! Hot steam may escape when the door is opened. Open the door

carefully.

Cancelling a delay start or a washing programme in progress

• Simultaneously press and hold the two programme buttons positioned over the word

RESET , until all the programme button lights will illuminate.

• Cancelling a delay start involves also the cancelling of the washing programme set. In

this case you have to set the washing programme again.

• If a new washing programme is to be selected, check that there is detergent in the

detergent dispenser.

Interrupt a washing programme in progress

• Open the dishwasher door; the programme will stop. Close the door; the programme will

start from the point at which it was interrupted.

End of the washing programme

• The dishwasher will automatically stop and an audible signal informs you of the end of

the washing programme.

• When the washing programme has ended, the optical signal on the floor beneath the

dishwasher's door will turn off.

1. Open the dishwasher door.

The indicator light of the programme just ended remains illuminated.

2. Switch off the dishwasher by pressing the On/Off button.

3. Leave the dishwasher door ajar and wait a few minutes before removing the dishes; in

this way they will be cooler and the drying will be improved.

Select and start a washing programme

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 95 96

No comments

Aeg-Electrolux F65010VI User Manual Page 80