8050 TW ElectronicUser manual Condenser Dryer withHeat Pump
What is shown in the display1 time to end / error message2 cycle phase status3 options4 warnings5 spin speed selection6 dryness selectionBefore first
Sorting and preparing laundrySorting laundry• Sort by fabric type:–Cotton/linen for programmes in COTTONS BAUMWOLLE pogramme group.–Mixtures and synth
Programme chartProgrammesmax. load (weight when dry)Additional func-tions/optionsApplication/propertiesCare markDRYNESS TROCKENGRADRPM U/MINLONG ANTI-
Programmesmax. load (weight when dry)Additional func-tions/optionsApplication/propertiesCare markDRYNESS TROCKENGRADRPM U/MINLONG ANTI-CREASEKNITTERSC
Programmesmax. load (weight when dry)Additional func-tions/optionsApplication/propertiesCare markDRYNESS TROCKENGRADRPM U/MINLONG ANTI-CREASEKNITTERSC
Opening loading door / loading laundry1. Open loading door:Use force to push against the loadingdoor (push point)2. Load your laundry (do not force it
Press the DRYNESS TROCKENGRAD buttonrepeatedly until the desired dryness level(MIN, MED or MAX) is shown in the display.When humidity adjustment is no
Setting long anti-crease function (KNITTERSCHUTZ PLUS)Press the LONG ANTI-CREASE KNITTER-SCHUTZ PLUS button. A 90 minute anti-crease phase is set. The
2.Press the TIME ZEITWAHL button repeatedly until the desired programme du-ration is shown in the display, e.g. 20 for a programme of 20 minutes.If th
If you want to set a new programme, you must first deactivate the child safetydevice.Starting the programmePress the START PAUSE button. The pro-gramm
Dear CustomerThank you for choosing one of our high-quality products.With this appliance you will experience the perfect combination of functionaldesi
Drying cycle complete / removing laundryOnce the drying cycle is complete, display shows a blinking "0", under anti-crease icon appear dash.
1. Open loading door2. Use a damp hand to clean the mi-cro- fine filter, which is built intothe lower part of the loading aper-ture.3. After a period
5. Take out fine strainer.6. Remove fluff from fine strainer. Itis best to use a damp hand for thispurpose.Clean the entire filter areaThe strainer ar
Emptying the condensate tankEmpty condensate tank after every drying cycle.If the condensate tank is full, an active programme will break off automati
To protect the heat pump from dirt, the dryer is fitted with fluff filter, which islocated in the filter housing. Here too large amounts of fluff buil
6. To clean the fluff filter: Remove fil-ter from filter housing. To do this,press the pressure points on thesides and pull the filter frame upand out
Cleaning the drumCAUTION!Do not use abrasives or steel wool to clean the drum.Lime in the water or cleaning agents may form a barely visible lining on
What to do if ...Troubleshooting by yourselfIf, during operation, the error code E... plus number or letter) appears on the LCD:Switch the machine o
Defective light bulb.Replace light bulb (see next sec-tion).Displayed programmetime changes errati-cally or stays un-changed for a longtime.Programme
Changing the bulb for interior lightingOnly use a special bulb which is designed specially for dryers. The special bulb canbe obtained from the Custom
ContentsOperating Instructions 5Important safety information 5Product description 8Control panel 9What is shown in the display 10Before fir
Machine settingsSetting ImplementationBUZZER SIGNAL permanentoff1. Turn the programme selector to any programme.2.Press simultaneously the DRYNESS TRO
Technical dataThis appliance conforms with the following EU Directives:– 73/23/EEC dated 19.02.1973 Low Voltage Directive– 89/336/EEC dated 03.05.1989
Consumption valuesThe consumption values have been established under standard conditions. Theymay deviate when the machine is operated in domestic cir
InstallationTransporting the applianceOnly tip the appliance on its left side to trans-port (see illustration), if it cannot be trans-ported in an upr
The hot air emitted by the tumble dryer can reach temperatures of up to 60°C. Theappliance must therefore not be installed on floors which are not res
Connect the machine to an earthed socket, in accordance with current wir-ing regulations.WARNING!The manufacturer declines any responsibility for dama
7.Unscrew cover plates D from thefront of the machine, rotatethrough 180°, screw on the oppo-site side.8.Unscrew door lock E, push downslightly and re
Installation kit 12512251. for direct draining of condensate into a basin, siphon,gully, etc. The condensate tank then no longer has to be drained, it
Environmental tips• In the dryer, laundry becomes fluffy and soft. Fabric softeners are not thereforeneeded when washing.• Your dryer will function mo
ServiceIn the event of technical faults, please first check whether you can remedy theproblem yourself with the help of the operating instructions (Ch
Troubleshooting by yourself 27Changing the bulb for interior lighting 29Machine settings 30Technical data 31Consumption values 32Hints fo
www.electrolux.comwww.aeg.ch136901501-00-09042008
Operating InstructionsImportant safety informationIn the interest of your safety and to ensure the correct use, before installingand first using the a
• Items that have been soiled with substances such as cooking oil acetone, petrol,kerosene, spot removers, turpentine, waxes and wax removers should b
• After having installed the appliance, check that it is not pressing or standing onits electrical supply cable.• If the tumble dryer is placed on top
Product description1123795148106121 Control panel2 Drawer with condensed water container3 Lamp for inside light4 Fine strainer (lint filter)5 Large me
Control panel1Programme knob and OFF AUS switch2 Function buttons3 START PAUSE button4DELAY START ZEITVORWAHL button5 Status led6 Display1 2 36 45Cont
Comments to this Manuals