Aeg-Electrolux S17TK58 User Manual download pdf (Page 32)

Using the Appliance

Before Use

Remove all securing tapes.

Wash the inside of the appliance

with lukewarm water with a little

bicarbonate of soda added (5 ml

to 0,5 litre of water). Do not use

soap or detergent as the smell

may linger. Dry the appliance

thoroughly.

Do not use detergents, abrasive

powders, highly perfumed cleaning products, wax polishes or products

containing alcohol.

To Start the Appliance

1. Allow the appliance to stand for 2 hrs after installation.

2. Plug in the appliance and switch on at the mains supply.

3. Turn the thermostat control to the required setting. A setting of 3 is usually

suitable for normal operation (see thermostat control).

4. Leave the appliance for approximately 4 hours for the correct temperature to

be reached before placing food inside.

Thermostat Control

The thermostat control situated inside the refrigerator regulates the

temperature of the larder compartment. Thermostat control is marked from

1-5 the higher the number, the colder the setting.

Position 0 - Off

Position 1 - minimum coldness

Position 5 - maximum coldness

Switching Off the Appliance

To switch off the appliance, turn the temperature regulator to position"0".

If the appliance is not going to be used for an extended period:

1. Remove all refrigerated packages.

2. Switch off the appliance by turning the thermostat knob to position"0".

3. Remove the mains plug or switch off or disconnect from the electricity

supply.

4. Clean thoroughly (see section: “Cleaning and Care”).

5. Leave the door open to avoid the build up of odours.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 79 80

No comments

Aeg-Electrolux S17TK58 User Manual Page 32