Aeg-Electrolux L12843VIT User Manual download pdf (Page 43)

4. Connect the hose to a tap with a 3/4” thread.

Always use the hose supplied with the appliance.

Installation should comply with local water authority

and building regulations requirements. A minimum

water pressure of 0.05 MPa is required for safe

operation of the appliance.

If you cannot make the cold water connection direct

from the rising mains, you may be able to operate the

appliance from your cold water storage system. There should be a minimum verti-

cal distance of between the appliance’s inlet and the bottom of the water storage

tank.

Water-stop device

The inlet hose is provided with a water stop device,

which protects against damage caused by water

leaks in the hose which could develop due to

natural ageing of the hose. This fault is shown by a

red sector in the window “A”. Should this occur,

turn the water tap off and refer to your Service

Centre to replace the hose.

Water drainage

This appliance is designed to be permanently plumbed

into your home's drainage system using one of the

following methods.

1. Into a drainage standpipe.

Firstly form a hook in the end of the drain hose using

the “U” piece” supplied.

Place the drain hose into your

standpipe, which should have an

internal diameter of approximately

38mm thus ensuring there is an air

break between the drain hose and

standpipe.

Installation

352

P1199

U piece

supplied

30 cm (12")

38 mm (11.2)

standpipe

diameter

132962540.qxd 28/07/2008 12.03 Pagina 43

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 51 52

No comments

Aeg-Electrolux L12843VIT User Manual Page 43