Aeg-Electrolux L98685FL User Manual

L 98485 FLL 98685 FLWASHING MACHINE USER MANUAL

IThe default spin speed of the programme._ _ _No spin 1)Rinse hold1) Only available for Spin/Drain programme.JThe default temperature of the programme

The programme duration in-creases.This function is not availablewith a temperature lower than40° C.VOORWASUse this function for heavy soil.The applian

WASHING PROGRAMMESProgramme Temperature Type of loadWeight of loadProgrammedescriptionFunctionsKatoen 95° - Cold White and col-oured cottonwith heavy

Programme Temperature Type of loadWeight of loadProgrammedescriptionFunctionsFijne Was 40° - ColdRinsesShort spinDelicate fabricsas acrylics, vis-cose

Programme Temperature Type of loadWeight of loadProgrammedescriptionFunctionsJeans 60° - Cold Items like pants,shirts or jacketsin Jeans and alsojerse

STEAM PROGRAMMESProgramme1)Type of load LoadStoom Opfrissen2)This cycle removes odour fromthe laundry.Steam does not removeanimal odours.Cotton and sy

BEFORE FIRST USE1. To activate the drain system, put 2litre of water in the main wash com-partment of the detergent dispens-er.2. Put a small quantity

4. The display shows the default tem-perature and spin. If it is necessary,touch button 12 and button 11 tochange the water temperature andthe spin sp

USING THE DETERGENT AND ADDITIVESThe detergent compartment for the prewash phase and the soakprogramme.Add the detergent for prewash and soak before t

3. To use powder detergent, turn theflap up.4. To use liquid detergent, turn theflap down.With the flap in the positionDOWN:– Do not use gelatinous or

The following symbols are used in thisuser manual:Warning - Important Safety information.General information and tipsEnvironmental informationSubject

The appliance adjust automat-ically the cycle time to thelaundry you have put in thedrum to have perfect washingresults in the minimum neces-sary time

The washing programme iscompleted, but there is water in thedrum:– The drum turns regularly to preventthe creases in the laundry.–The door stays locke

you use a water softener for washingmachines. In areas where the waterhardness is soft it is not necessary touse a water softener.To know the water ha

DOOR SEALRegularly examine the seal and removeall objects from the inner part.DRUMRegularly examine the drum to preventlimescale and rust particles.On

DRAIN PUMPRegularly examine the drainpump and make sure that it isclean.Clean the pump if:• The appliance does not drain the wa-ter.• The drum cannot

7. Remove fluff and objects from thepump.8. Make sure that the impeller of thepump can turn. If this does not oc-cur, contact the service centre.129.

4. Remove the inlet hose behind theappliance.5. Clean the filter in the valve with astiff brush or a towel.45°35°6. Install again the inlet hose. Make

Problem Possible cause Possible solutionThe display tellsto check the tap:the appliancedoes not fill withwater.The water tap is closed. Open the water

Problem Possible cause Possible solution The filter of the drainpump is blocked.Clean the filter of the drainpump. Refer to 'Care and clean-ing&

Problem Possible cause Possible solution You did not remove thestubborn stains beforeyou wash the laundry.Use special products to removethe stubborn

FOR PERFECT RESULTSThank you for choosing this AEG product. We have created it to give youimpeccable performance for many years, with innovative techn

TECHNICAL DATADimensions Width / Height / Depth 600 / 850 / 600 mm Total depth 640 mmElectrical connection: VoltageOverall powerFuseFrequency230 V220

4. Remove the internal film.5. Open the door. Remove the poly-styrene piece from the door sealand all the items from the drum.6. Put the front piece o

9. Remove the power supply cable andthe drain hose from the hose hold-ers.10.Remove the three bolts. Use the keysupplied with the appliance.11.Pull ou

POSITIONING AND LEVELLINGx4• Install the appliance on a flat hardfloor.• Make sure that carpets do not stopthe air circulation below the appli-ance.•

• Connect the water inlet hose to thecold water tap with 3/4 thread.CAUTION!Make sure that there are noleaks from the couplings.Do not use an extensio

• On the edge of a sink.• Make sure that the plastic guide can-not move when the appliance drains.Attach the guide to the water tap orthe wall.• To a

www.aeg-electrolux.com/shop 132940560-A-482010

SAFETY INFORMATIONBefore the installation and use, readthis manual carefully:• For your safety and the safety of yourproperty• To help the environmen

WARNING!Do not look directly into thebeam of the lamp.To replace the internal lamp,contact the service centre.Disconnect the mains plug fromthe mains

ENVIRONMENT CONCERNSPACKAGING MATERIALSRecycle the materials with the symbol .Put the packaging in applicable con-tainers to recycle it.ECOLOGICAL HI

ACCESSORIES1 2341SpannerTo remove the transit bolts.2Plastic capsTo close the holes on the rear sideof the cabinet after the removal ofthe transit bol

•Before press button 6 , you do notuse the appliance for five minutes.Press button 1 to activate the appli-ance again.• After 5 minutes from the end o

• The end time of the washing programme .Programme end symbolThe symbol comes on when the digits shows the pro-gramme end time.•The time of delay– Whe