AEG Electrolux EFT 520 Operations Instructions download pdf (Page 13)

The Thyrovox VR was ﬁxed to a transport pallet with four screws at the factory ready for transport

and packaged in foil to protect against moisture and paint damage.

To prepare for transport at the installation site remove the packaging and the transport pallet from

the Thyrobox VR.

6.1 TRANSPORT WITH CRANE OR HOIST

FIG. 1 CRANE TRANSPORT EYES ON THE THYROBOX VR

After removing the packaging the Thyrobox VR and the concrete pedestal can be transported to

the set-up site.

DO NOT WALK UNDER SUSPENDED LOADS!

Wear personal protective gear (helmet, safety shoes, working gloves)!

Always carry out the transport with the necessary caution, adhering to the safety requirements!

ONLY TRANSPORT DEVICE IN UPRIGHT POSITION!

Do not tip or tilt! Avoid shifting the center of gravity!

The device may not be hoisted by its construction parts!

Measure the length of the slinging gear (cable, chain or straps) so that there is an angle of more

than 45° between the slinging gear and the upper side of the device (DIN 580).

Use separate slinging gear for each transport eye, so 4 sets of slinging gear in total.

6. TRANSPORT

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 37 38

No comments

AEG Electrolux EFT 520 Operations Instructions Page 13