AEG Electrolux EFT 520 Operations Instructions download pdf (Page 27)

After commissioning or switching on the Thyrobox VR does not require any further operational

handling.

NOTE

If required the setpoint for the voltage to be regulated can be congured for each phase – however,

this is not normally required. For this requirement the PC software Thyro-Tool Family, which is

supplied as part of the package, is needed as well as a data cable (9-pole) and possibly the adapter

cable for the implementation of USB 1.1 RS 232 (also included in the scope of supply).

To avoid operational errors, parameter and/or setpoint alterations are only to be made by trained

personnel.

Alternatively there is the option of contacting the support service of AEG Power Solutions.

12.1 OPERATING WITH Thyro-Tool Family SOFTWARE

Before conﬁguring the voltage setpoint the Thyro-Tool Family software provided must be installed

along with the driver for the USB RS232 adapter (if needed).

Alter voltage setpoint:

1. Insert the data cable into the frontal RS232 terminal of the Thyro-P control device. This can take

place whilst the device is running.

2. Connect the data cable with the PC/laptop. If no RS232 interface is available on the PC, use the

adapter USB RS232 supplied in the package (install driver for USB adapter).

3. Start Thyro-Tool Family software

12. OPERATION

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 37 38

No comments

AEG Electrolux EFT 520 Operations Instructions Page 27