AEG Electrolux PE3820-M User Manual download pdf (Page 12)

tion (or ESC (B6) to cancel). "HOT WATER

PRESS OK" is displayed.

12. Press the OK icon (B9) again. The appliance

begins delivering hot water and the message

"PLEASE WAIT... " is displayed.

When delivery stops, the appliance automa-

tically displays the basic modes set again.

N.B.!

The appliance may request the ope-

ration to be repeated a number of times until the

air is completely elminated from the hydraulic cir-

cuit.

Replacing the filter ("Filter reset")

When "REPLACE FILTER" is displayed or after 2

months of use (see date indicator), the filter must

be replaced:

1. Remove the exhausted filter;

2. Remove the new filter from the packaging.

3. Slide the pointer of the date indicator (see fig.

30) until the months of use are displayed (the

filter lasts about 2 months);

4. Insert the filter in the water tank and press it

until it touches the bottom of the tank (see

fig. 30);

5. Fill the water tank and place it in the coffee

maker, then insert the hot water spout (C7)

(fig. 6).

6. Position a container under the spout (min.

capacity: 100 ml).

7. Press the icon (B2) to enter the menu;

8. Press the icons (B7) and (B8) until "FIL-

TER RESET" is displayed;

9. Press the OK icon (B9);

10. The message "FILTER RESET CONFIRM" is

displayed.

11. Press the OK icon (B9) to confirm the selec-

tion (or ESC (B6) to cancel). "HOT WATER

PRESS OK" is displayed.

12. Press the OK icon (B9) again. The appliance

begins delivering hot water and the message

"PLEASE WAIT..." is displayed.

When delivery stops, the appliance automa-

tically displays the basic modes set again.

Removing the filter

To use the appliance without a filter, you must re-

move it and notify the appliance of its removal as

follows:

1. Press the icon (B2) to enter the menu;

2. Press the icons (B7) and (B8) until "IN-

STALL FILTER*" is displayed;

3. Press the OK icon (B9);

4. The message "INSTALL FILTER* CONFIRM" is

displayed.

5. Press the ESC icon (B6).

6. When the asterisk has disappeared from the top

right of the display, press ESC (B6) to exit the

menu.

N.B.!

Use the filters recommended by the

manufacturer only. Use of unsuitable filters could

damage the appliance.

TURNING ON AND HEATING

Each time the appliance is turned on, it performs

an automatic preheat and rinse cycle which can-

not be interrupted.

The appliance is ready for use only after comple-

tion of this cycle.

Danger of burns!

During rinsing, a little

hot water flows from the coffee spouts.

To turn the appliance on, press the On-Off/stand-

by button (A7) (fig. 1). The message "HEATING

UP... PLEASE WAIT" is displayed.

When heating is complete, the message changes

to "RINSING";

The appliance is at temperature when the mes-

sage "MEDIUM CUP NORMAL TASTE" is displa-

yed.

If no icon is pressed within about 2 minutes, the

time (if set, see the "Setting the clock" section) is

displayed.

If the time has not been set, the appliance di-

splays the last functions set.

When any icon is pressed, "MEDIUM CUP NOR-

MAL TASTE" is displayed again. The appliance is

Downloaded from CoffeeMachineManual.com Manuals

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 29 30

Comments to this Manuals

No comments

AEG Electrolux PE3820-M User Manual Page 12

Comments to this Manuals

Related products and manuals for Coffee makers AEG Electrolux PE3820-M