AEG Electrolux PE3820-M User Manual download pdf (Page 11)

12

USING THE APPLIANCE

FOR THE FIRST TIME

• Coffee has been used to factory test the ap-

pliance and it is therefore completely normal

for there to be traces of coffee in the mill.

• Customise water hardness as soon as pos-

sible following the instructions in the "Setting

water hardness" section.

1. Connect the appliance to the mains supply.

Set the required language.

2. To set the language, use the icons (B7

and B8) to choose the required language (fig.

2). When the message "PRESS OK TO

CHOOSE ENGLISH" is displayed, press the

OK icon (B9) (fig. 3) for 3 seconds until "EN-

GLISH INSTALLED" is displayed. If you set

the wrong language, follow the instructions

in the "Setting the language" section. If your

language is not available, select one from

those displayed. The instructions refer to the

English version. Then follow the instructions

displayed:

3. After 5 seconds, the appliance displays "FILL

TANK". Extract the water tank (fig. 4), rinse

and fill with fresh water without exceeding

the MAX line. Replace and push as far as it

will go. A water softener filter can be instal-

led in the tank (fig. 30).

4. Place a cup under the hot water spout (fig.

5). (If the hot water spout is not inserted, the

appliance displays "INSERT WATER SPOUT".

Attach it as shown in figure 5. Press the OK

icon (B9) (fig. 3) and after a few seconds a

little water comes out of the spout.

5. The machine now displays "TURNING OFF...

PLEASE WAIT" and goes off.

6. Extract the appliance by pulling it out using

the handles (fig. 7). Open the lid and fill the

container with coffee beans, then close the

lid and push the appliance in.

The coffee maker is now ready for normal use.

Important!

Never introduce pre-ground

coffee, freeze dried coffee, caramelised beans or

anything else which could damage the appliance.

N.B.!

When using the appliance for the

first time, you need to make 4-5 cups of coffee

and 4-5 cappuccinos before the appliance gives

satisfactory results.

N.B.!

Each time you turn the coffee maker

on by the ON/OFF switch (A23), it performs a

SELF-DIAGNOSIS cycle and then goes off. To

turn it on again, press the ON/OFF button (A7)

(fig. 1)

Installing the filter

Some models are fitted with a water softener fil-

ter to improve the quality of the water used and

extend the working life of the appliance.

To install, proceed as follows:

1. Remove the filter (A26) from the packaging;

2. Slide the date indicator pointer (see fig. 30)

until the months of use are displayed.

N.B.!

The filter lasts about two months if

the appliance is used normally. If the coffee

maker is left unused with the filter installed,

it will last a maximum of three weeks.

3. Fill the tank with a little water up to the level

shown in the figure:

4. Insert the filter in the water tank and press it

until it touches the bottom of the tank (see

fig. 30);

5. Fill the water tank and place it in the coffee

maker, then insert the hot water spout (C7)

(fig. 6).

6. Position a container under the spout (min.

capacity: 100 ml).

7. Press the icon (B2) to enter the menu;

8. Press the icons (B7) and (B8) until "IN-

STALL FILTER" is displayed;

9. Press the OK icon (B9);

10. The message "INSTALL FILTER PLEASE

CONFIRM" is displayed.

11. Press the OK icon (B9) to confirm the selec-

Downloaded from CoffeeMachineManual.com Manuals

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 29 30

Comments to this Manuals

No comments