Aeg-Electrolux B89090-4 User Manual Page 20

  • Download
  • Add to my manuals
  • Print
  • Page
    / 24
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 19
20
Oven Shelves and Shelf Supports
To clean the oven shelves, soak in warm soapy water and remove
stubborn marks with a well wetted soap impregnated pad.
Rinse well and dry with a soft cloth.
The shelf supports can be removed for easy cleaning.
Proceed as follows:
1) remove the front screw while keeping the shelf support in
position with the other hand (Fig. 35);
2) disengage the rear hook and take off the shelf support
(Fig. 35);
1) once the cleaning is carried out, refit the shelf supports
following the procedure in reverse.
Please, ensure the retaining nuts are secure when refitting the
shelf support.
When cleaning the shelf supports, take care not to
remove the lubricating grease behind the telescopic
runners. This is meant to ensure their good operation.
)
Fig. 35
)
Replacing the Oven Light
If the oven bulb needs replacing, it must comply with the
following specifications:
- Power: 25 W,
- Voltage: 230 V (50 Hz),
- Temperature Rating of 300°C,
- Thread type: E14.
These bulbs are available from your local Service Force Centre.
To replace the faulty bulb (Fig. 37):
1. Ensure the oven is disconnected from the electrical supply.
2. Turn the glass cover anticlockwise.
3. Remove the faulty bulb and replace with the new one.
4. Refit the glass cover.
5. Reconnect to the electrical supply.
Fig. 37
The Hinged Grill
Some models are fitted with a hinged grill element, to enable
you to clean the roof of the oven easily.
Before proceeding ensure the oven is cool and is
isolated from the electricity supply.
z Undo the screws which hold the grill in place (see Fig. 36).
When doing this operation for the first time, we recommend
using a screwdriver.
z Then gently pull the grill downward to allow access to the
oven roof.
z Clean the oven roof with a suitable cleaner and wipe dry
before replacing the hinged grill element.
z Gently push up the grill element into place and firmly screw
into place the holding nuts.
Ensure the grill holding nuts are firmly in place to
avoid the grill falling down when in use.
Fig. 36
Page view 19
1 2 ... 15 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments