AEG Electrolux 700 D Operations Instructions download pdf (Page 9)

The static bypass switch is activated in the event of a mains

failure. The inverter then takes over the voltage supply of the

connected loads, in order to prevent the risk of data loss or

damage to the loads. PROTECT A. supplies voltage until the

battery is discharged or your IT system has been shut down

and switched off properly.

The standby time mainly depends on the connected loads. If

the mains power supply is back to normal values, the UPS will

switch back the loads to mains supply. The battery charger

will then recharge the battery.

For safety reasons (as required by German standards, VDE),

the mains input in the unit will be disconnected by a two-pole

switch in the event of a mains failure. Energy backfeed to the

mains and voltage supply to the pins of the mains connector

are thus reliably avoided.

Furthermore, additional measures ensure effective protection

for the data/network interface.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

No comments

AEG Electrolux 700 D Operations Instructions Page 9