Aeg-Electrolux L50840 User Manual download pdf (Page 37)

1. Set the hose correctly by loosening the ring nut.

After positioning the inlet hose, be sure to tighten

the ring nut again to prevent leaks.

2. Connect the hose to a tap with a 3/4” thread.

Always use the hose supplied with the appliance.

The inlet hose must not be lengthened. If it is too

short and you do not wish to move the tap, you

will have to purchase a new, longer hose specially

designed for this type of use.

Water drainage

The end of the drain hose can be positioned in three ways:

Hooked over the edge of a sink using the

plastic hose guide supplied with the machine.

In this case, make sure the end cannot come

unhooked when the machine is emptying.

This could be done by tying it to the tap with a piece

of string or attaching it to the wall.

In a sink drain pipe branch. This branch must be

above the trap so that the bend is at least 60 cm above

the ground.

Directly into a drain pipe at a height of not less than 60 cm and not more

than 90 cm.

The end of the drain hose must always be ventilated, i.e. the inside diameter of

the drain pipe must be larger than the outside diameter of the drain hose.

The drain hose must not be kinked.

Important!

The drain hose may be extended to a maximum of 4 metres. An additional drain hose and

joining piece is available from your local Service Centre.

Installation

P1118

132969511.qxd 25/10/2008 11.38 Page 37

1 2 ... 32 33 34 35 36 37 38 39 40

No comments

Aeg-Electrolux L50840 User Manual Page 37