Aeg-Electrolux L61470WDBI User Manual download pdf (Page 17)

10.7 Interrupting a

programme

Press button Start/Pause to interrupt a

programme which is running, the

corresponding indicator starts blinking.

Press button Start/Pause again to restart

the programme.

10.8 Cancelling a running

programme

Turn the selector dial to Ein/Aus to

cancel a programme which is running.

Now you can select a new programme.

Before starting the new

programme the appliance

could drain the water. In this

case, make sure that the

detergent is still in the

detergent compartment, if

not fill the detergent again.

10.9 Opening the door

When the appliance is working and

through the delay time, the door is

locked.

If, for any reason, it is necessary to open

it, firstly press button Start/Pause to set

the machine to pause.

If the indicator Tür after a few minutes

goes off, the door can be opened.

If the indicator Tür stays on and the door

remains locked, this means that the

appliance is already heating or that the

water level is too high. In this case the

door cannot be opened.

If you cannot open the door but you

need to open it, turn the programme dial

to Ein/Aus to switch the appliance off.

After a few minutes the door can be

opened (pay attention to the water

level and temperature !) .

After closing the door, it is necessary to

set the programme and the options

again. Press button Start/Pause to start

the programme again.

10.10 At the end of the

programme

The appliance stops automatically. The

indicator of button Start/Pause, the

indicators Waschen and Tür go off. A

blinking will appear on the display.

If you have set a programme or an

option that ends with water in the tub,

the indicator Tür remains on. The door is

locked. The water must be emptied out

before opening the door. During this

time the drum continues to turn at

regular intervals until water drain.

Follow the below instructions to empty

out the water:

• Turn the programme selector dial to

Ein/Aus.

• Set the DRAIN or SPIN programme.

• Reduce the spin speed, if needed.

• Press button Start/Pause.

• When the programme has finished

the display shows a blinking . The

indicator Tür goes off. The door can

be opened.

Turn the programme selector dial to

Ein/Aus to switch the appliance off.

Remove the laundry from the drum and

carefully check that the drum is empty. If

you do not intend to carry out another

wash, close the water tap. Leave the

door open to prevent the formation of

mildew and unpleasant smells.

10.11 Stand by

Once the programme has finished, after

few minutes the energy saving system

will be enable. The brightness of the

display is reduced. By pressing any

button the appliance comes out from the

energy saving status.

11.

DAILY USE - DRYING ONLY

WARNING!

Refer to Safety chapters.

ENGLISH 17

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 39 40

Comments to this Manuals

No comments